Owner`s manual

CUTTING CROWN MOLDING cont.
Bevel
Angle Setting Type of Cut
Left side, Inside 90 =corner
1.Top edge ol molding against fence
2. Miter table set right 31.62 _
3. Save left end of cut
33.85 °
Right side, Inside 90 ° corner
1. Bottom edge of molding against fence
33'85° 2. Miter table set left 31,62 °
3. Save left end of cut
Left side, outside 90° corner
33.850 t. Bottom edge of molding against fence
2. Miter table sat left 31.62"
3. Save right end of cut
33.85 °
Right side, outside 90" corner
1.Top edge of molding against fence
2. Miter table set right 31,62 °
3. Save dght end of cut
CUTTING WARPED MATERIAL (See Figures 29 - 30)
When cutting warped material, ALWAYS make sure that it is positioned on the
miter table with the convex side against the fence, as shown in Figure 29.
If the warped material is positioned the wrong way, as shown in Figure 30,
it will pinch the blade near the end of the cut.
[ Z_WARNING: To avoid kickback and to avoid serious personal injury NEVER
position the concave edge of bowed or warped material against the fence,
38
........................................................................................................................................................................................................................... i