Owner`s manual

CLAMPING WIDE WORKPIECES
(See Figure 31)
When cutting wide workpieces
(such as 2-in x 6-in. boards),
the boards should ALWAYS
be clamped with a hold-down
clamp or C-clamp as shown
in Figure 31.
GENERAL
I
I
Z_WARNING: To avoid accidents, ALWAYS disconnect the tool from
the power source BEFORE cleaning or performing any maintenance.
/I'_WAHHIHLi: Preventive maintenance performed by unauthorized
personnel may result in misplacing of internal wires and components,
which could cause a serious hazard.
I
I
• All service that requires opening the saw MUST only be performed by a Sears
Service Center. All motor parts represent an important part of the double insulation
system and MUST only be serviced by a Sears Service Center. Service performed
by unqualified personnel could result in a risk of injury.
• When servicing this tool, ALWAYS use only identical replacement parts. Follow
instructions in the Maintenance Section of this manual. Use of unauthorized parts
or failure to follow Maintenance Instructions may create a risk of electrical shock
or injury.
• Avoid solvents when cleaning plastic parts. Most plastics are susceptible to damage
from various types of commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, carbon dust, etc.
I Z_WARNING: DO NOT at any time let brake fluids, gasoline, petroleum- I
I
based products, penetrating oils, etc., to come in contact with plastic parts.
I
They contain chemicals that can damage, weaken or destroy plastic.
39