Manual

SERVICE

WARNING: Preventive maintenance performed by unauthorized

personnel may result in misplacing of internal wires and components,

which could cause a serious hazard,

1. Tool service MUST BE performed only by a Sears Service Center.

Service or maintenance performed by unqualified personnel could result

in a risk of injury.

IMPORTANT NOTE: All service that requires opening the saw should only be

performed at a Sears Service Center.

2. When servicing a tool, ALWAYS use only identical replacement parts. Follow

instructions in the Maintenance Section of this manual. Use of unauthorized

parts or failure to follow Maintenance Instructions may create a risk of electric

shock or injury.

GENERAL

WARNING: To avoid accidents, ALWAYS disconnect the tool from

the power source BEFORE cleaning or performing any maintenance.

All parts represent an important part of the double insulation system and

should be serviced only at a Sears Service Center.

Avoid using solvents when cleaning plastic parts. Most plastics are

susceptible to damage from various types of commercial solvents and

may be damaged by their use. Use clean cloths to remove dirt,

carbon dust, etc.

Z_ WARNING: DO NOT at any time let brake fluids, gasoline,

petroleum-based products, penetrating oils, etc. to come in contact

with plastic parts. They contain chemicals that can damage, weaken

or destroy plastic.

It is a known fact that electric tools are subject to accelerated wear and

possible premature failure when they are used to work on fiber glass

wallboard, spackling compounds or plaster.

Thechips and grindings from these materials are highly abrasive to electrical

tool parts, such as bearings, brushes, commutators, etc. Consequently,

it is not recommended that this tool be used for extended work on any

fiber glass material, wallboard, spackling compound, or plaster.

During any use on these materials, it is extremely important that the tool

is cleaned frequently by blowing with an air jet.

LUBRICATION

All of the bearings in this tool are lubricated with a sufficient amount of

high-grade lubricant for the life of the tool under normal operating conditions.

Therefore, no further lubrication is required.

WARNING: ALWAYS wear safety goggles or safety glasses with

or side shields when using this tool or blowing dust. If operation is dusty,

also wear a dust mask.