Owner`s manual

Safety and Assembly Instructions
CRRFTSMRN®
FLEX SHAFT for
ALL-IN-ONE
CUTTING TOOL
ASSEMBLY INSTRUCTIONS
t.
2.
Turn cutting toolmotor switch OFF and remove
plugfrom the power source.
Lock main shaft (3) by rotatingthe collet nut(1)
while pressing on the spindle lockbutton(4)
untilthe spindle lock preventsshaft from
rotating (see Fig 1).
Model No.
183.287660
3.
Use cutting toolfiat wrench (5) to loosenthe
collet nut by turningit counter clockwise.
Remove collet(2) from insidemain shaft of
cutting tool.
IAWA.N,.GJ
ALWAYS WEAR EYE PROTECTION. Any power
tool can throw foreign
objects into your eyes
which could cause
permanent eye damage.
ALWAYS wear safety
goggles (not glasses) that
comply with ANSI safety
standard Z87.1. Everyday glasses have only
impact resistant lenses. They ARE NOT safety
glasses, Safety goggles are available at most
hardware stores,
Glasses or goggles not in compliance with ANSI
Z87.1 could cause serious injury when they
break.
USE FACE OR DUST MASK along with safety
goggles if cutting or routing operation is dusty.
Make sure work area is well ventilated.
NEVER PLACE HANDS IN THE PATH OF THE
CUTTER or under the workpiece.
USE HEARING PROTECTION, particularly
during extended periods of operation,
ALWAYS RE-TIGHTEN COLLET before starting
the tool after a cutting bit or accessory has
been changed. Loose bits and accessories can
cause unexpected shifting of the tool, resulting
in loss of control and injury from the bit or
cutting tool being thrown.
NEVER TOUCH THE CUTTING BIT
IMMEDIATELY AFTER USE. The bit will be too
hot to be handled with bare hands and will burn
your fingers.
2 3
Fig. 1
4. Insert collet withsquare hole (6) intomain shaft
(3) and re-installthe collet nut(1) ontothe main
shaft (see Fig. 2).
NOTE: Coll_t with square hole is packedwith
the flex shaft package.
5. Use cutting tool fiat wrench (5) to tightenthe
colletnut firmty onto the main shaft while
spindle lockis engaged into the main shaft,
Turn nut clockwise to tighten.
Fig. 2
Sears, Roebuck and Co., Hoffman Estates, IL 60179 USA
Part. No. 183287660003 Rev. 3 07129102