Manual

,
,
Next, lower the head by turning the head crank handle counter-
clockwise until the clutch clicks several times (at least 5 clicks
recommended).
The clutch is intended to load the board against the traction drive
with consistent force. In certain cases the machine can sense if the
workpiece is not loaded enough and repeatably display "Please
Load Board" on the LCD. Most often this decreased loading is
caused by insufficient lubrication of the four vertical corner posts or
the two vertical leadscrews. Please see the Checking the Head
Pressure in the troubleshooting section for the proper lubrication
procedure.
The head-locking lever is then rotated outward into the locked
position. The workpiece is now secure and ready to be carved.
9. Make sure that the top safety cover is closed before proceeding.
Locking Lever
.... In Locked Position
FIGURE 18: LOCKING LEVER CONFIGURATION
Make sure that the locking lever is released after finishing carving.
If the locking lever is NOT released the head will not be able to
move up and down.
WARNING: Failure to correctly load the clutch by ratcheting it
at least five times may result in diminished carving quality.
Sears, Roebuck and Co. CompuCarve TM System (Rev 1.6) 09/27/06 Page 22