Manual

Cocking the Quick Release Chuck
The quick release chuck must be cocked in order to install a bit. To cock
the chuck, press all the way up on the chuck release flange (See Figure
25) and release. The outer flange will snap up when the chuck is
prepared to receive the bit assembly. Any time difficulty is encountered
inserting a bit and adapter simply pull up on the flange to insure the chuck
is cocked.
Bit Assembly Installation
When a carving function has been selected from the display menu, the
CompuCarve will move the cutting head to the center of the machine and
prompt for the required bit.
Quick
Release
Chuck
FIGURE24: QUICK RELEASE CHUCK
To insert a bit: lift up on the front safety cover, cock the quick release
chuck, and press the bit assembly into the chuck until a slight snap is felt.
Close the cover and press the ENTER key. The machine will proceed
with measuring the bit and processing the selected task.
Be certain to insert only the proper bit requested; damage to
the workpiece and/or damage to the CompuCarve machine
may result from installing incorrect cutting bits.
All motors are disabled whenever the cover is open. The cover
must be closed before the machine can proceed.
Sears, Roebuck and Co. CompuCarve TM System (Rev 1.6) 09/27/06 Page 29