Manual

15
To Connect the Control Console to the Opener
Connect the pair of wires from the control console
to the pair of “PUSH BUTTON” terminals on the
rear of the opener. Refer to Wiring Instructions
on page 13 to ensure wires are properly connect-
ed.
The push standard control console is a wired, illuminated door
control placed inside your garage.
Door Control Console Installation
● Inside your garage, install the control console within sight of
the door at a minimum height of 5 feet (1.5 m) above the
floor.
● Ensure that the console is installed out of reach of children
and is free from contact with moving parts of the door.
● Install the console onto a solid mounting surface. If mount-
ing to drywall, drill 3/16" holes and use provided drywall
anchors.
1. Hold the console against the mounting surface and mark
the console bottom hole position on the surface.
2. Remove the console from the surface. Drill a 5/32” pilot
hole at the mark. Install the bottom screw into the surface.
Allow 1/8” of the screw to protrude above the surface. Posi-
tion bottom hole on back of console over the screw and
slide console down into place.
3. Lift the console actuation cover to expose the top screw
hole. Mark the top screw hole position on the mounting sur-
face. Remove the console from the surface and drill a 5/32”
pilot hole at the mark.
4. Position bottom hole on back of console over the bottom
screw and slide console down into place. Install the top
screw through the top screw hole and into the mounting
surface.
To prevent SERIOUS INJURY or DEATH from electrocution:
- Power MUST NOT be connected until instructed.
To prevent SERIOUS INJURY or DEATH from using the push button and a closing door:
- Install the control console within sight of the door at a minimum height of 5 feet (1.5m) above the floor.
Make sure it is out of the reach of children and moving parts of door and hardware.
- NEVER permit children to access the control console or remote controls.
- Operate the door ONLY when it is adjusted properly with no obstructions present and is in clear sight.
- ALWAYS keep a moving door in sight until it’s completely closed.
- NEVER cross the path of a moving door.
Control Console
Min. 5 feet (1.5m)
above floor
From Control Console
Connecting Standard Control Console
!
WARNING
Drywall Anchor
Screw #6 x1-3/8
NOTICE: Only use the Control Console included with this GDO model or identical replacement part.
See Accessories in Repair Parts section of this manual.
PUSH BUTTON