Manual

18
!
WARNING
To prevent SERIOUS INJURY or DEATH from improper Force Adjustment:
- YOU CANNOT adjust force manually to compensate for binding or sticking of the garage door. Call a
qualified garage door service person to make necessary adjustments in case of binding.
- YOU CANNOT manually increase the force required for closing the door.
- After ANY adjustments, Safety Reverse Test MUST be performed to ensure the door reverses on contact
with a 1.5” high object (2x4 laid flat).
Travel Limit Adjustment— I. UP Limit
x1
UP
DOWN
FORCE
LIMIT
UP
DOWN
UP
DOWN
FORCE
LIMIT
UP
Trolley
Minimum 2” (5cm) clearance
Desired UP limit
Flashes and off
I. Setting UP Limit
UP
DOWN
FORCE
LIMIT
UP
DOWN
OK
1
2
3
5
About Travel UP Limit Adjustment
Travel “UP” Limit Adjustment regulates the fully-open (UP limit)
position. This step will program how far the opener will open the
garage door.
Make sure the trolley is engaged, photo eyes are installed
P.15 and photo eyes are aligned P.17 before proceeding
with adjustments.
I. Setting Travel UP Limit
1. Press and Release “LIMIT” button ONCE to enter Travel
Limit Adjustment. “UP” indicator (green) will turn on*.
*NOTE: Once you have pressed and released the “Limit”
button, the “UP” light will stay on for 10 seconds. You
must press & hold the “UP” button within 10 seconds to
begin programming. If the “UP” light turns off before
pressing and holding the “UP” you will need to start over.
2. With green indicator on, press & hold the “UP” button,
the door will travel up. You may use both “UP” or
“DOWN” buttons to inch-adjust the door to the desired
UP limit position.
3. DO NOT HIT STOP BOLT! There is a minimum 2“ (5cm)
gap between Trolley and Stop Bolt.
4. Make sure there is enough clearance for your vehicle(s),
to enter and exit the garage door.
5. Once the door is at the desired UP limit position, press
and release “LIMIT” button once, “OK” indicator (orange)
flashes and goes off. The UP limit is set.
NOTICE: This opener will not work until you set the travel limits and the auto
force adjustment. You must follow all steps on pages 18,19,20.
Continue to page 19 for down limit
* DO NOT HIT STOP BOLT *
Press & Release
Press & Hold Up
x1
Press & Release
Stop Bolt