Manual

TROUBLESHOOTING: Status & Diagnostic Chart - beeps

SYMPTOM: Opener does not respond to remote control.

● Check remote control battery.

● Program remote control.

● 2 Beeps: 'Vacation Lock' may be activated on deluxe control (if installed) (Refer to page 22 to program

remote control)

SYMPTOM: Opener stops before reaching full open/closed position.

● Travel Limit is not properly adjusted.

Check adjustment (Conduct safety reverse test after ANY adjustment).

(

Refer to pages18-20 to reverse test & travel force)

● If door is obstructed or force setting related, please count the BEEPS and refer to the "TROUBLESHOOTING:

Diagnostic Chart - Beeps" (Page 27).

SYMPTOM: Door reverses unintentionally.

● Make sure the photo eye safety system is aligned and clear of obstructions.

● A door spring that has relaxed, door or track alignment that has changed or a sudden change in temperature could

create the phantom obstruction sensed.

(Refer to pages 18-20 to check the travel limits & travel force)

● Check for a broken door spring

(

Refer to page 4 to check the door balance)

● Call a qualified service technician to check the door or replace the spring.

SYMPTOM: If courtesy lamp does not turn ON ,replace light bulb.

● Replace light bulb (A19 incandescent Max. 100W).

● If after light bulb is replaced, and courtesy lamp still does not turn ON, replace logic board.

SYMPTOM: Courtesy light does not turn OFF.

● If deluxe door control console installed, press courtesy light on/off switch. If after pressing light on/off of deluxe

door control dose not work, then replace logic board.

Red LED

Green LED

Red LED

Green LED

Red LED

Green LED

Red LED

Note: If installing operators on two doors in the same garage, Photo Eyes should be aligned as below:

Troubleshooting