Owner`s manual

OPERATION
MOTOR TILT POSITION (FIG. 6&7)
Tilting the motor can be used when launching boat,
beaching, mooring boat in shallow area or trailering
(when using a trailering bracket to support engine). To
tilt motor :
Push tilt release lever(A) down to "Release" posi-
tion.
• Grasp handle (B) on back of motor cover and pull
forward until motor clicks into raised position.
Push tilt lock(C) down to verify motor is locked.
• To return motor to operating position, grasp han-
dle on back of motor cover and pull slightly for-
ward. Pull the tilt lock (C) up to release motor.
• Lower motor into water slowly.
• Push the tilt release lever (D) up to"Engage" posi-
tion.
FULL TILT POSITION
Figure 6 C
D
Figure 7
III
CO-PILOT ADJUSTMENT IS NOT INTENDED
TO ALLOW "HANDS OFF" STEERING. LOSS
OF CONTROL AND SERIOUS INJURY COULD
OCCUR.
CO-PILOT ADJUSTMENT (FIG. 8)
• Yourmotorhas an adjustable steeringfriction fea-
ture to allowyou to adjust the effortnecessary to
steer.
• -'_it motor up and lock in position.
• Adjust screw (A) for steering friction desired.
Figure 8
SHALLOW WATER OPERATION
(FIG.9)
The shallow water drive bar allows the motor to oper-
ate at low speeds in shallow water, by being partially
tilted to allow more bottom clearance.
Tilt the motor and lock it in the full ti!t position
(Fig.6).
Lift the shallow water drive bar (A) up until it clicks
into it's "up" position.
Pull the tilt lock (C) in Figure 7, up and slowly low-
er the motor making sure that the shallow water
drive bar (A) rests against the transom angle pin 0
(B).
7
SHALLOW WATER OPERATION
Figure 9
_IN.