Operator`s manual

ASSEMBLY

3. Insert the round end of the chute control rod into input of chute

control head. Push rod as far into the chute control head as pos-

sible, keeping the holes in the rod pointing upward. See Figure 4.

4. Place chute onto chute base and ensure chute control rod is

positioned under handle panel. Secure chute control head to

chute support bracket with clevis pin and bow-tie cotter pin

removed in step 1. See Figure 5.

5. Finish securing chute control head by installing hex bolt and wing

nut. See Figure 6.

6. Insert the other end of the chute control rod into the input shaft

below the handle panel. Make sure to line up the flat end of the

rod and the flat end of the input shaft. You may need to rotate the

rod around until these two surfaces line up. See Figure 7.

Figure 5

Figure 6

Figure 4

Figure 7