Owner`s manual

RULES FOR SAFE OPERATION (Continued)
11. USE SAFETY GLASSES with all tools.
12.
13.
14.
15.
Also face or dust mask if cutting
operation is dusty.
DON'T ABUSE CORD. Never carry tool by cord or yank it to disconnect from
receptacle. Keep cord from heat, oil and sharp edges.
SECURE WORK. Use clamps or a vise to hold work. It's safer than using your
hand and it frees both hands to operate tool.
DON'T OVERREACH. Keep proper footing and balance at all times.
MAINTAIN TOOLS WITH CARE. Keep tools sharp at all times, and clean for best
and safest performance. Follow instructions for lubricating and changing ac-
cessories.
16. DISCONNECT TOOLS. When not in use, before servicing, or when changing at-
tachments, blades, bits, cutters, etc., all tools should be disconnected.
17. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see
that keys and adjusting wrenches are removed from tool before turning it on.
18. AVOID ACCIDENTAL STARTING. Don't carry plugged-in tools with finger on
switch. Be sure switch is off when plugging in.
19. OUTDOOR USE EXTENSION CORDS. When tool is used outdoors, use only
extension cords suitable for use outdoors. Outdoor approved cords are marked
with the suffix W-A, for example -- SJTW-A or SJOW-A.
20. NEVER THIS USE THIS OR ANY POWER SANDER FOR WET SANDING. Failure
to comply can result in electrical shock causing serious injury or worse.
21. KEEP HANDS AWAY FROM SANDING AREA.
22. NEVER USE IN AN EXPLOSIVE ATMOSPHERE. Normal sparking of the motor
could ignite fumes.
23. INSPECT TOOL CORDS PERIODICALLY and if damaged, have repaired at your
nearest Sears Repair Center.
24. INSPECT EXTENSION CORDS PERIODICALLY and replace if damaged.
25. KEEP HANDLES DRY, CLEAN, AND FREE FROM OIL AND GREASE. Always
use a clean cloth when cleaning. Never use brake fluid, gasoline, or any strong
solvents to clean your tool.
26. STAY ALERT. Watch what you are doing and use common sense. Do not op-
erate tool when you are tired.
27. CHECK DAMAGED PARTS. Before further use of the tool, a guard or
other part that is damaged should be carefully checked to determine that it will
operate properly and perform its intended function. Check for alignment of mov-
ing parts, binding of moving parts, breakage of parts, mounting, and any other
conditions that may affect its operation. A guard or other part that is damaged
should be properly repaired or replaced by an authorized service center unless
indicated elsewhere in this instruction manual.
28. DO NOT USE TOOL IF SWITCH DOES NOT TURN iT ON AND OFF. Have
defective switches replaced by authorized service center.
29. Inspect for and remove all nails from lumber before sanding.
30. DRUGS, ALCOHOL, MEDICATION. Do not operate tool while under the influ-
ence of drugs, alcohol, or any medication.
31. SAVE THESE INSTRUCTIONS.
CAUTION
The operation of any sander can result in foreign objects being thrown in.
to the eyes, which can result in severe eye damage. Always wear safety
glasses or eye shields before commencing power tool operation. We
recommend Wide Vision Safety Mask for use over spectacles, or stan-
dard safety glasses .... available at Sears Catalog Order or Retail Stores.
Page 3