Specifications

11Crafted with CRAFTSMAN MARINE
Settings
I – Calibration of the revolution counter
In order to achieve the correct indication of the revolution counter, this instrument
must be calibrated with the engine. Please take following steps:
1. This work can best be done by 2 persons.
2. Measure the number of engine revolutions with a manual
revolution counter at the crank shaft.
3. Set the engine at 2000 revolutions.
4. As soon as the manual revolution counter indicates 2.000 revs, adjust the
revolution counter in the instrument panel accordingly.
The revolution counter can be calibrated by 3 methods (A, B or C ). Select your most
convenient method:
A. Fine-tuning (direct setting)
This method allows for an adjustment of -20% to +20% as opposed to the factory
setting.
When the engine is in operation:
1. Keep the button at the back of the revolution counter depressed, in order to
increase the indication figure.
2. If the button is released and kept depressed thereafter, the indication figure of the
revolution counter will be decreased.
3. Adjust the number of revolutions of the revolution counter in the panel by the same
value as indicated by the manual revolution counter.
B. Adjust (adjustment via menu)
This method allows for adjustment if the indication is within the bracket between
30% en100% (1200-4000 rpm)
When the engine is in operation:
1. Keep the button at the back of the revolution counter depressed and position the
starter switch in the “ON” position.
2. The display will now show the text PULSE or ADJUST.
3. Push the button until the word ADJUST will show.
4. Release the push button.
5. Now keep the button at the back depressed in order to raise the indicated number
of revolutions.
6. If the button is released and kept depressed thereafter, the indication figure of the
revolution counter will be decreased .
7. Adjust the number of revolutions of the revolution counter in the panel by the same
value as indicated by the manual revolution counter.
8. Turn the starter switch to the “OFF” position and thereafter to the “ON” position.
C. Pulse - (adjustment via menu)
This method allows for adjustment if it is known how many pulses per revolution are
generated by the alternator or the sensor. This method does NOT involve the starting
up of the engine.
Action to take:
1. Keep the button at the back of the revolution counter depressed and position the
starter switch in the “ON” position.
2. The display will now show the text PULSE or ADJUST.
3. Push the button until the word PULSE will show.
4. Release the push button.
5. The display will now show the number of pulses/revolutions as per the factory
setting. Example: 1 2 3 . 4 5
6. Figure 5 will now begin to blink (maximum 3 times). Press the button in order to
increase or decrease the figure. At first the values will be increased, thereafter
decreased.
7. If you do no react after three times blinking, following figures will start to blink
successively: 4, 3,2 and 1.
8. Adjust with the aid of these figures the required number of pulses/revolutions.
9. After completion of figure 1 , the menu will close down automatically. This can
also be achieved by cutting off the voltage supply.
5