Specifications

8 Crafted with CRAFTSMAN MARINE

Installation

1. Determine the correct position for the panel, in a

place where the skipper has a clear survey of the

panel and where no heavy vibrations can occur.

2. If the control panel is fitted outside , the cover for

the starter switch must be fitted too, so as to avoid

dirt and (sea) water entering into the switch. Only

the top side of the panel is watertight.

3. Cut out a hole into the steering stand with the aid

of the supplied drilling pattern.

4. Position the gasket at the bottom of the panel; a

recess to receive the gasket is provided all around

in the edge.

5. Connect the extension cables type A and B with the

engine control/instrument panel.

6. Fit the panel with the aid of the 4 screws and

plastic washers, supplied.

1. Remove the plastic ring

2. Remove the nut

3 Position the cover

4. Fit the nut and the cover

Engine control/ instrument panel

Fix the position of the panel at the rear with the aid of

the bracket supplied.

Engine control/instrument panel ALFA40E

Cover (see pictures below)