Manual

SPOOL REPLACEMENT
.......i. _op motorand Unplug power Cord.
2. P,estmlnrearplate, pushintockbutton (lecatedon hub),and twist
hubcounter-clockwiseuntlllocklng tabsdlsengag_ Remo_ehub.
3. Remove spool from assembly and removespring-from Spool.
4. Rewlndispoolfn accordance with theInstructionsIncludedherein
(fig.6). or replace,spool as approprlate_
5. Beforemlnst_illng spool be sureapproximately3 Inel_esoffine
exits spool between the_twofoam pads as shown In fig.S.
6. install spring on '_OP SIDE" of spool. See fig.5.
7. Insert line thin eyeletInhubassernbly and seat epdng end onto
center post Inside hub assembly.
NOTE: Make surelinedoes not get trapped underspool,between
the spool and hub assembly, •
8._ Slidespoolandhubassemblyontomotorshaft.Manlpulateparts
- sltghtlytbobtaln pmp_;rallgnmenL LIftihg uponrear plate_align
looking tabs onhubassembly with s!ots in rearplate and insert
• .tabs _nto slots until parts bottom. Rotate hub _assembly
_io0_ise Whlieres.tr_Intngth_ rearp|ate until all four i0_ing "
tabs are proped;yengaged;
9: RemoVedebris.from,underslde of your WEEDWACKEFL
IFLINE DOES NQTEEED "
t.-. Follow instructions 1.3 unde_:"_3pool Replacement:'
2_ Check to make. sure:llhe Iswound Indirection indicated
on spool,, " ""
3. Separate strandsof tangled line or install new line if
necessary.
4. In.spect foam pad for te_Lmof damage, replace if necessary.
5/ Check spring for damage and proper Installation."
6. Follow tnst(uetlons.5_thru .9 under "Spool Replacement."
FIG_5
REWINDING SPOOL
..... When rewinding be s_re to Windthe line in the directionofarrow
indicated on spool (Fig.6) Plastic isa memorymaterial and the line
should be receded form the original coilto the spoolin a way so the
built-inmemory tbndsto keep the coilstightto the spool, ifyou recoil
in theopposite direction the coils wouldbe loose and tend to come
unwound. To secure line tospool, place tape over approx. 1_,_"of
line, then secure tape to ,s_f. Line must be,wound side by side
avoidingcrossoveror crisscrossingto insureproper lineadvancing,
Do not wind more than a total of 40 feet Qfline onto spool.
FIGo6
RECOMMENDEDREPLACEMENTPARTS
ANDACCESSORIES
Your SEARS WEEDWACKER uses SPECIALLY TREATED .065
DIAMETER MONORLAMENT NYLON cuttingline whP..his available
at SEARS STORES AND CATALOG STORES, You may purchase
a fullywoundspool (PaR No. 80"744)oryoumay purchasea package
of two 50 foot co{Is(Part No, 85772) ora large bulkspool of lineand
rewind your present spool.
CAUTION: The use of heavierline,differenttypesof lineandac-
eessodesorattachments otherthanrecommendedmay be hazar-
dousor causeunitfailure.
5