Use And Care Manual

4
Items Needed:
¼-20 X 1/2" Carriage Bolt (Qty: 8)
5/16 Washer (Qty: 8)
¼-20 Serrated Flange Nut (Qty: 8)
Process:
• Attach remaining rail in top back set of holes in (2) side
panels as shown, using (4) bolts, (4) washers, and (4)
nuts. Flanges of rail should point out.
• Attach cross member as shown, using (4) screws, (4)
washers, and (4) nuts.
• Finger tighten.
• Square the unit and wrench tighten all fasteners.
Items Needed:
#14-10 X 5/8" Hex Screw (Qty: 13)
Process:
• Position frame assembly on workbench top, as desired.
Note: The back of the work bench frame must be at least
1-1/2 inches (38 mm) from the back of the workbench top.
• Mark centers of (8) mounting holes.
• Move workbench assembly for access.
• Drill (8) 1/8" pilot holes 1/2" deep in mounting hole
locations.
• Reposition workbench assembly on workbench top.
• Attach using (8) screws.
Note: Additional fasteners may be used to attach
workbench top through holes in side support if desired.
(Not supplied)
• Place the workbench in its upright position.
• Position the back splash centered against back of
workbenchtopwithangeunderneath.
• Mark center of (5) mounting hole locations using the
holesinangeofbacksplashasatemplate.Makesure
back splash does not move.
• Remove back splash for easier access top top.
• Drill (5) 1/8" pilot holes, 1/2" deep, in mounting hole
locations.
• Reposition back splash on workbench top.
• Attach using (5) screws.
OPERATION
Leveling Foot Adjustment
•Adjustlevelingfoottodesiredpositionwithathead
screwdriver or 7/16 open end wrench as shown.
Front
Back
Flanges
point out
¼-20 Serrated
Flange Nut
5/16 Washer
¼-20 X 1/2”
Carriage Bolt
Screw
Flange
underneath
Front
1-1/2 inches
38 mm
Pilot holes
Cross
member
Square