\ 71L{ <;,t l ® MODEL NUMBER 917.372471 OWNER'S MANUAL IlL{ 11?7 1 - Assembly , Operation • Maintenance • Service - Adjustments • Repair Parts Caution: Read and Follow all Safety Rules and Instructions Before Operating This Equipment I IIIIIIIIIIII ..
SAFETY RULES PLUGTO PREVENT ACCIDENTAL STARTING WHEN SETTING UP, TRANSPORTING, ADJUSTING OR MAKING CAUTION: ALWAYS DISCONNECT SPARK PLUGWIRE AN DPLACE WIRE WHERE IT CANNOT CONTACT SPARK REPAIRS. IMPORTANT SAFETY STAN DARDS REQUIRE OPE RATOR PRESEN CE CONTROLS TO MINtMIZE THE RIS K OF INJU RY. YOU R U N IT IS EQU IPPED WIT H SUCH CONTROLS. DO NOT ATTEMPT TO DEFEAT THE FUNCTION OF THE OPERATOR PRESENCE CONTROLS UNDER ANY CIRCUMSTANCES.
CONGRATULATIONS on your purchaseof a Sears Craftsman LawnMower.Ithasbeendesigned, engineered and manufacturedto give you the best possibledependability andperformance. Shouldyou experienceany problemsyou cannoteasily remedy,pleasecontactyournearestSearsServiceCenter/Department. Searshascompetent, welltrainedtechniciansandthepropertoolstoserviceor repairthis unit. Pleasereadandretainthis manual.Theinstructions will enableyouto assembleandmaintainyourlawnmower properly.Alwaysobservethe SAFETYRULES.
TABLE OF CONTENTS SAFETY RULES ............................................. PRODUCT SPECIFICATIONS ........................ 2 3 CUSTOMER RESPONSIBILITIES ......... . ....... WARRANTY ................................................... LAWN MOWER ACCESSORIES ................... ASSEMBLY .................................................... OPERATION ................................................... 3 3 5 6 7 MAINTENANCE ............................................ 12 SERVICE AND ADJUSTMENTS ...........
LAWN OWE ACCESSO These accessories were available when this lawn mower was produced. They are also available at most Sears retail outlets, catalog and service centers. Most Sears stores can also order repair parts for you, when you provide the model number of your lawn mower. Some of these accessories may not apply to your lawn mower.
ASS LY Your lawn mower has been assembled at the factory except for the grass catcher bag and the grass catcher frame, TO REMOVE CARTON LAWN MOWER UPPER HANDLE FROM LIFT UP • • Remove loose parts included with mower. Cut down two end corners of carton and lay end panel down flat. • Remove all packing materials except padding between upper and lower handle and padding holding operator presence control bar to upper handle.
OPERATION KNOW YOUR LAWN MOWER READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR LJkWN MOWER. Compare the illustrations with your lawn mowerto familiarize yourself with the location of various controls and adjustments. Save this manual for future reference, ENGINE ZONE CONTROL CABLE OPERATOR PRESENCE DR_VE CONTROL CONTROL BAR LEVER STARTER HANDLE CABLE CLiP ENGINE OtL CAP W!DIPSTICK GRASS CATCHER GASOLINE CAP PRIMER AiR FILTER HOUSING WHEEL ADJUSTER (ON EACH WHEEL) F_G.
OPERATION HOW TO USE YOUR LAWN MOWER ENGINE CAUTION; Do not run your Iawn mower without mulcher plate in place and door clipping deflector or grasscatcher in latch in locked position or approved place. Never attempt to operate the tawn mower withthe rear door removed or propped open. ENGINE SPEED (See Fig. 4) The engine speed is controlled by a lever (red knob) located on the side of the engine. "HIGH" (,1_)position is for starting the engine, normal cutting, and better grass bagging.
OPERATIO TO EMPTY ° ° • GRASS CATCHER (See Fig. 8) To remove grass catcher, release operator presence control bar to stop engine. Lift up rear door and remove the grass catcher by the handle. Do not drag the bag when emptying; unnecessary wear. DRIVE CONTROL it wilt cause (See Fig. 9) o Self-propelling is controlled by holding the operator presence control bar down to the handle and pushing the drive control lever forward until it clicks; then release the lever.
OPERATIO BEFORE STARTING ENGINE OIL CAP W/DIPSTICK ENGmNE \ OIL (See Fig. 11) A 20 oz. bottle of Pennzoit SAE 30 oil is included with your new lawn mower. • o • • • ° , Remove engine oil cap and fii! to the FULL line on the dipstick. Use 20 ozs. of SAE 30 oil. SAE 10W30 oil can atso be used. All oil must meet API service classification SG. DO NOT use SAE 10W 40 oil. POUR OIL SLOWLY. DO NOT OVERFILL. Check oil level before each use. Add oil if needed. Fill to FULL line on dipstick.
OPE 0 MOWRNG TiPS , Under certain conditions, such as very tall grass, it may be necessary to raise the height of cut to reduce pushing effort and to keep from overloading the engine and leaving clumps of grass clippings. o For extremely heavy cutting, reduce the width of cut and raise the rear of the lawn mower housing one (1) wheel adjuster setting higher than the front for better discharge of grass.
MAINTENANCE MAINTENANCE SCHEDULE FtLL iN DATES AS YOU COMPLETE REGULAR SERVICE SERVICE DATES Check for Loose Fasteners Cleanifnspect Grass Catcher Clean Lawn Mower Inspect Mower Blade Replace/Sharpen Mower Blade Lubricate Pivot Points Check Engine Oil Level Change Engine Oil Inspect Muffler Replace Spark Plug Replace Air Filter Paper Cartridge I - Change more often when operating under a heavy Load or in high ambient temperatures, 2 - Service more often when operating in dirty or dusty conditions,
A CE AINTE LAWN MOWER CRANKSHAFT & BLADE ADAPTER DETAIL BLADE Always observe safety rules when performing any mainteRanGe. TIRES , Keep tires free of gasoline, oil, or insect control chemicals which can harm rubber. ADAPTER - Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage. BLADE CARE KEY For best results, mower blade must be kept sharp. Replace bent or damaged blades. TO REMOVE BLADE (See Fig. 13) • Turn lawn mower on its side.
MAINTENANCE ENGINE LUBRICATION Change the oil after the first two hours of operation and every 25 hours thereafter or at least once a year if the lawn mower is not used for 25 hours in one year. Check the crankcase oil level before starting the engine and after each five (5) hours of continuous use. Add SAE 30 motor oil or equivalent. Tighten oil plug securely each time you check the oil level. ONTAtNER TO CHANGE ENGINE OIL (See Fig, 14) . • . o . Remove engine oil cap; lay aside on a ciean surface.
SERVICE AND ADJUSTIVl CAUTtON: TS BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: •• Releasecontrol bar, and atl moving Make sure the btade o Disconnect spark plug wire from spark plug and place where it cannot come in contact parts have completely stopped. with plug. LAWN MOWER TO ADJUST CUTTING See "TO ADJUST CUTTING section of this manual.
ENGlNE TO ADJUST CARBURETOR TOP NO LOAD SCREW (See Fig. 18 ) Minor carburetor adjustments may be required to compensate for differences in fuel, temperature, altitude or toa.d. The air cleaner and air cleaner cover must be assembled to carburetor when running. IDLE SPEED ADJUSTING SCREW INITIAL ADJUSTMENTWith the engine not running, gently turn idle mixture screw clockwise until it just closes. Screw may be damaged by turning it in too far.
SERVICE AND ADJUSTMENTS TO ADJUST HANDLE (See Figs. lg Thru 21) SHIPPING POSITION Your lawn mower handle can be raised or lowered for your mowing comfort. Four (4) positions are available: high, medium high, medium low and low. Handles are shipped mounted in the medium low position. • • • • • o o • MEDIUM LOW To change from medium low to medium hugh position, the upper and lower handle sections will have to be turned over (See Fig. 19B).
STORAGE .... ,,, ,',ran,,, ,, ENGINE Immediately prepare your lawn mower for storage at the end of the season or if the unit will not be used for 30 days or more. FUEL SYSTEM IMPORTANT: IT _S IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL.
TROUBLES O0 G POI TS PROBLEM CAUSE CORRECTION Does not start 1. 2+ 3, 4. Dirtyair filter. Out of fuel+ State fuel. Water in fuel. t, 2. 3. 4+ Clean/replace air fitter. Fill fueitank, Drain tank and refill with fresh clean fuel. Drain fuel tank and carburetorand refi_l tank with fresh 5, 6. 7. 8, 9, Spark plug wire is disconnected. Bad spark ptug, Loose btade or broken bIade adapter. Control bar in released position Control bar defective 5, 6. 7+ 8, 9.
CRAFTSMAN REPAIR PARTS 22" ROTARY LAWN MOWER MODEL NUMBER 917.
% CRAFTSMAN 22" ROTARY LAWN MOWER MODEL NUMBER KEY PART NO. NO DESCRiPTiON KEY PART NO. NO DESCR|PT_ON 1 2 3 4 5 8 7 8 9 t0 11 12 13 14 15 t8 t7 !8 19 20 21 22 23 24 25 28 27 28 28 30 31 32 33 34 Upper Handte Engine Zone Controf Cable Hex Head Bolt !/4-20x 1-1/2 Locknut 1/4-20 Cable Clip Handle Knob Locknut !/4-20 Control Bar Rear Door Kit (Incl.
CRAFTSMAN 22" ROTARY LAWN MOWER MODEL NUMBER 917°372471 54 14 7 \ 23 24 REPAIR PARTS
CRAFTSMAN KEY NO.
REPAIR PARTS 22" POWER- PROPELLED LAWN MOWER 917,372471 GEAR CASE ASSEMBLY PART NUMBER 751001 t5 t0 p. 9 ! 8 | REF. PART NO. NO. t 2 3 4 5 6 53838 85178, 88386 57072 57388 48032 7 8 9 t0 77881 77039 750430 57079 DESCRIPTION REFo PART NO. NO. DESCRtPT?ON Keps Locknut 1/4-20 Adjusting Bracket Shifter Assembly Seal Grooved Pin 1/8 x 1/2 Gear Case Halves (lncl. Upper & Lower Halves) (incl. Ref.
MODEL NO, 124702 TYPE NO.
MODEL NO, 124702 TYPE NOo 3186-0! BR_GGS & STRATTON 4°CYCLE ENGINE 968 % 969 t 24 971A %.
MODEL NOo ] 2:4702 TYPE NO.
MODEL NO. 124702 TYPE NO.
MODEL NO. 124702 TYPE NO, 318(}-01 BRaGGS & STRATTON 4-CYCLE ENG6NE KEY NO. 1 2 PART NO.
SERVICE 30 NOTES
SERVICE 31 NOTES
£RUFTXMrlN® OWNER'S MANUAL 5.0 HORSEPOWER 22" REAR DISCHARGE 2 in ONE Mulcher/Bagger POWER PROPELLED ROTARY LAWN MOWER Each Lawn Mower has its own model number. engine has its own model number. MODEL NO. 917.372471 Each The model number for your lawn mower will be found on a decal attached to the rear of the lawn mower housing. The model number for the engine will be found on the Blower Housing of the engine adjacent to the spark plug.
