Owner`s manual

,_ WARNING: Always wear safetygoggles or
safety glasses withside shieldswhen operating
tools. Failure to do so could result in objects
being thrown intoyour eyes, resulting in possible
serious injury.
DRILLING
See Figure8.
WARNING: Be prepared for binding or bit
breakthrough. When these situations occur,drill
has a tendency to grab and kick oppositeto the
direction of rotationand could cause lossof
controlwhen breakingthroughmaterial. If not
prepared,this lossof controlcan resultin
possibleserious injury.
When drilling metals, use a light oil on the drill bit to
keep itfrom overheating.The oil will prolongthe lifeof
the bitand increasethe drillingaction.
Ifthe bit jams in workpieceor ifthe drillstalls, release
switchtriggerimmediately.Removethe bitfrom the
workpieceand determine the reasonfor jamming.
LEVEL DRILLING
See Figure 9.
Aconvenientfeature provided withyour ddll is a level.
It is recessed in the motorhousingon top ofyourdrill.
Itcan be usedto keep drillbitslevel duringdrilling
operations.
Fig. 8
When drillinghard smoothsurfaces usea center
punch to mark desiredhole location.This willprevent
the drill bit from slipping off center as the hole is
started.
The materialto be drilled shouldbe securedin a vise
or with clampstokeep it from turningas the drillbit
rotates.
Hold toolfirmly and placethe bit at the point to be
drilled. Depressthe switchtriggerto starttool.
Move the drillbit into the workpieceapplying only
enough pressureto keepthe bit cutting.Do notforce
or applyside pressureto elongatea hole.
Fig. g
10