Owner`s manual

RULES FOR SAFE OPERATION (Continued)
21_ DO NOT USE TOOL IF SWITCH DOES NOT
TURN IT ON AND OFF. Have defective switches
replaced by an authorized service center.
22_ DRUGS, ALCOHOL, MEDICATION. Do not
operate toot while under the influence of drugs,
alcohol, or any medication. 31,
23° DRILLING OR DRIVING SCREWS INTO
ELECTRICAL WIRING IN WALLS, CEILINGS,
OR OTHER AREAS CAN CAUSE THE BIT OR 32.
CHUCK TO BECOME ELECTRICALLY LIVE. Do
not touch metal parts when drilling into a wall; 33°
grasp onlythe insulated handle(s) or plastic housing
when using this tool. Make sure hidden electrical
wiring, water pipes, and mechanical hazards are
not in the path of the bit when drilling into a wail
24_ INSPECT FOR and remove all nails from lumber 34.
before drilling.
RULES FORIMPORTANT SAFETY
BATTERY TOOLS
and water, then neutralize with lemon juice or
vinegar. If liquid gets in your eyes, flush them with
clean water for at least 10 minutes, then seek
immediate m,edical attention,
tfcarrying your battery tool at your side, make sure
it is not running and your finger is not on the switch,
Avoid accidental starting°
SECURE WORK before applying power. NEVER
hold workpiece in your hand or across your legs.
WHEN SERVICING USE ONLY IDENTICAL
CRAFTSMAN REPLACEMENT PARTS.
IMPORTANT SAFETY
FOR CHARGER
35.
25. Battery tools do not have to be plugged into an
electrical outlet; therefore, they are always in
operating condition. Be aware of possible hazards
when not using your battery tool or when changing 36.
accessories.
26° USE ONLY THE CHARGER PROVIDED WITH
YOUR BATTERY TOOL. Do not substitute any
other charger. Use of another charger could cause
batteries to explode causing possible serious injury.
27° DO NOT PLACE BATTERY TOOLS OR THEIR 37°
BATTERIES NEAR FIRE OR HEAT, They may 38°
explode°
28, DO NOT CHARGE BA'I-rERY TOOL IN A DAMP
OR WET LOCATION.
iNSTRUCTIONS
29° Your battery tool should be charged in a location
where the temperature is more than 50°F but tess
than 100°F.
30° Under extreme usage or temperature conditions,
battery leakage may occur. If liquid comes in
contact with your skin, wash immediately with soap
39°
40_
SAVE THESE INSTRUCTIONS. This manual
contains important safety and operating
instructions for battery charger part number
999555-007.
Before using battery charger, read all instructions
and cautionary markings in this manual, on battery
charger, and product using battery, charger.
WAIRNBNG:
To reduce risk of injury, charge only nickel-
cadmium type rechargeable batteries. Other
type_, of batteries may burst causing personal
injury and damage,
Do not expose charger to rain or snow°
Use of an attachment not recommended or sold
by the battery charger manufacturer may result in
a risk of fire, electric shock, or injury to persons°
To reduce risk of damage to charger body and
cord, pull by charger body rather than cord when
disconnecting charger_
Make sure cord is located so that it will not be
stepped on, tripped over, or otherwise subjected
to damage or stress,.
WARNnNG'.
The operation of any power tool can result in foreign objects being thrown into your eyes,
which can result in severe eye damage. Before beginning power tool operation, always wear
safety goggles or safety glasses with side shields and a full face shield when needed. We
recommend Wide Vision Safety Mask for use over eyeglasses or standard safety glasses with
side shields, available at Sears Retail Stores.
Page 3