Flourescent Light Operator's Manual

A WARNING: When servicing, useonlyIdentlcel
Craftsman replacementpaKs. Use of any other part
may create a hazard or cause product damage.
_lb WARNING: Do notat anytime lat brakefluids,
gasoline, petroleum-basedproducts,penetrating oils,
etc. come in contact with plastic pans. They contain
chemicals that can damage, weaken or destroy
plastic.
Do not abase powertools. Abusive practicescan damage
tool as well as workplece.
A WARNING: Do notattempt to modifythis worklight
or create accessories notrecommendedfor use with
this worldlght.Any suchalteration or modificationIs
misuseand could result tn a hazardouscondition
leading to possible seriouspersonalinjury.
FLUORESCENT TUBE REPLACEMENT
See Figure 4.
When purchasingreplacementfluorescent tube, request
recommendedpart number7819602. See Figure5.
TO REPLACE FLUORESCENT TUBE;
• Remove battery pack from workllght. See Page 8.
• Remove screwto release lenscover. Remove lens
cover by pullingforwardand lifting from the housing.
• To remove old fluorescent tube from spdng, gently
grasp the lower edge of the rubber cushionand sides
of bulb, Carefully worktube in a side-to-side motion
while easingtube forward and up untiltube Is free from
the spnng. Do not pullfluorescent tube straight out
from its center, as this Increases chance of breakage.
Remove rubbercushionfrom oldfluorescenttube and
place on top of new tube, rounded edge facing
outward,
• Insert new fluorescenttube in spdng by aligning prongs
on tube withholes Intube socketarea, Gently push
down on base of new tuba untilfully engaged. Do not
forcetube into place.
• Replace lenscover by slidinglower edge into housing.
Align screw holes at top, With a hand tool,tighten
screw.Do not use drtllincludedtn kitto tighten screw,
as drilltorque may damage lens cover.
• Replace battery pack.
PULL LENS COVER RUBBER
FORWARD TO REMOVE CUSHION
SCREW
LENS COVER
FLUORESCENT TUBE _J BULB
SOCKET AREA Fi_.5