Operator`s manual

SWITCH
See Figure 3.
Your hand vac is equipped with an ON/OFF switch
located on top of hand vac. As shown in the arrows in
Figure 3, to turn your hand vac ON, push switch forward.
To turn it OFF, pull switch back.
SWITCH
TO TURNON
_TOTURN OFF
Fig. 3
TO INSTALL BATTERY PACK
• Place battery pack in hand vac aligning raised rib on
battery pack with groove inside hand vac. See Figure 4.
BATTERYPACK
LATC S _ r_-"_! _
TO
RELEASEBATTERYPACK
Fig. 4
• Make sure the latches on each side of battery pack
snap into place and battery pack is secured in hand
vac before beginning operation.
_ AUTION: When placing battery pack in hand vac,
be sure raised rib on battery pack aligns with groove
inside hand vac and latches snap into place properly.
Improper assembly of battery pack can cause
damage to internal components.
CLEANING YOUR HAND VAC
See Figures 5, 6, and 7.
_ ARNING: Never use your hand vac without the
filter properly in place.
The dust bowl should be checked, emptied and cleaned
periodically to obtain maximum dust collection.
TO REMOVE DUST BOWL
• Depress dust bowl release button located on top of
hand vac then pull bowl down and out as shown in
Figure 5.
DEPRESSDUSTBOWL
RELEASEBUTTON
TO
REMOVE
TO
INSTALL
HANDVAC
DUSTBOWL Fig. 5
• Remove the filter by simply pulling it out of dust bowl.
See Figure 6.
TO
REMOVE
HANDVAC
TO
DUSTBOWL INSTALL
FILTER
Fig. 6
• Shake or lightly brush any dust or dirt off filter.
• Empty dust bowl and wash if necessary. Make sure
dust bowl is completely dry before reattaching to hand
vac.
TO REMOVE BATTERY PACK
• Locate latches on side of battery pack and depress to
release battery pack from hand vac. See Figure 4.
• Remove battery pack from hand vac.