Operator`s manual

SWITCHLOCK
See Figure 5,
The switch trigger can be bcked in the OFF position. This
feature can be used to prevent the possibility of accidentaU
starting when not in use. To bck switch trigger, pUacethe
direction of rotation sebctor (Forward/Reverse Sebctor)
in center position. Note: When sebctor is in center
position, switch trigger is bcked.
SELECTORWiTH
CENTERLOCK POSITION
REVERSE
KEYLESS CHUCK
See Figure 6,
Your drHUhas a keybss chuck. As the name implies, you can
hand tighten or rebase drHUbits in the chuck jaws. Grasp and
hoUdthe collar of the chuck with one hand. Rotate the chuck
body with your other hand. The arrows on the chuck
indicate which direction to rotate the chuck body in order to
LOCK (tighten) or UNLOCK (release) the drill bit.
UNLOCK CHUCK
(RELEASE) COLLAR
DRILL BIT
SWITCH
TRIGGER
FORWARD
Fig, 5
_ WARNING: Battery tools are always in operating
condition. Therefore, switch should always be locked
when not in use or carrying at your side.
REVERSIBLE
See Figure 5,
This tool has the feature of being reversible. The direction
of rotation is controlled by a selector located above the
switch trigger. With the drill held in normal operating
position, the direction of rotation selector should be
positioned to the left of the switch for drilling. The drilling
direction is reversed when the selector is to the right of
the switch. When the selector is in center position, the
switch trigger is locked.
,_ CAUTION: To prevent gear damage, always allow
chuck to come to a complete stop before changing
the direction of rotation.
To stop, release switch trigger and allow the chuck to come
to a complete stop.
CNUCKJAWS
LOCK CHUCK
(TIGHTEN) BODY
Fig. 6
_ WARNmNG: Do not hold chuck body with one hand
and use power of the drill to tighten chuck jaws on
drill bit. Chuck body could slip in your hand or your
hand could slip and come in contact with rotating drill
bit. This could cause an accident resulting in serious
personal injury.
11