Owner`s manual

MAINTENANCE
WARNING:
When servicing use only identical Craftsman replacement
parts. Use of any other parts may create a hazard or
cause product damage.
J
GENERAL
Only the parts shown on parts list, page 13, are intended to
be repaired or replaced by the customer. All other parts
represent an important part of the double insulation system
and should be serviced only by a qualified Sears service
technician.
Avoidusingsolventswhen cleaning plasticparts.Most plastics
are susceptible to vadous types of commercial solvents and
may be damaged by their use. Use clean cloths to remove
dirt, carbon dust, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc. come in contact
with plastic parts. They contain chemicals that can
damage, weaken, or destroy plastic.
When electdc tools are used on fiberglass boats, sports cars,
wallboard, spackling compounds, or plaster, it has been
found that they are subject to accelerated wear and possible
premature failure, as the fiberglass chips and gdndings are
highly abrasive to bearings, brushes, commutators, etc.
Consequently itisnot recommended that thistool be used for
extendedworkonanyfiberglass material,wallboard, spackling
compounds, or plaster. Dudng any use on these matedals, it
is extremely important that the tool is cleaned frequently by
blowing with an air jet.
WARNING:
Always wear safety goggles, or safety glasses with side
shields dudng power tool operation or when blowingdust.
If operation is dusty, also wear a dust mask.
EXTENSION CORDS
The use ofany extension cordwillcause some lossofpower.
To keep the lossto a minimum andtopreventtooloverheating,
use an extension cord that is heavy enough to carry the
current the tool will draw.
Awire gauge size (A.W.G.) ofat least 16 is recommended for
an extension cord 100 feet or less in length. When working
outdoors, use an extension cord that is suitable for outdoor
use. The cord's jacket will be marked WA.
CAUTION:
Keep extension cords away from the sanding area and
position the cord so that it will not get caught on lumber,
tools, etc., during sanding or polishing operation.
WARNING:
Check extension cords before each use. If damaged
replace immediately. Never use tool witha damaged cord
since touching the damaged area could cause electrical
shock resulting in serious injury.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions.Therefore, nofurther lubrication
is required.
ACCESSORIES
THE FOLLOWING RECOMMENDED ACCESSORIES ARE
CURRENTLY AVAILABLE AT SEARS RETAIL STORES.
Polishing Bonnet Assorted Sandlng Discs
150 Grit m Fine
100 Grlt -- Medium
60 Grlt -- Coarse
40 Grit -- Very Coarse
WARNING: The use of attachments or accessories not listed above might be hazardous.
Page 10