Sander User Manual

SWITCH
Animportantnewfeature ofyour sanderisthe switch
design.It hasmulti-finger controlfor use when operatingat
differentangles or sandingpositionsand to help reduce
fatigue.
Italso has a lock-onfeature in the switchfor added utility
and convenienceon extendedwork requirements.
Carefullyread and understandthe following instructionsfor
correctoperationof the switchbeforeconnectingyour
senderto powersupply.
To Activate Switch:
To startyoursander, depress the switch triggerand switch
actuatorat the sametime. See Figure4.
Note: The partsofthe switchcan be easily identifiedby
theircolor.The switch trigger is red. The switch actuator is
black.
"LOCK-ON" FEATURE
• Start your sanderby depressingthe switch triggerand
switchactuator.
• Continueto holdyour sanderinthe ON positionwith
yourfingertipsand release the switchtrigger. See
Figures5 and 6.
• Release the switchactuatorand graspyoursanderby
the handleas showninfigure7.
TO RELEASE "LOCK-ON" FEATURE
• Depressthe switch triggerand release it. See Figure 8.
,_ WARNING: Before connectingyour sender to
powersupplysource, always check to be sure itis
not in"lock-on" position.Failure to do socould
resultinaccidental startingofyour sander resulting
in possible seriousinjury.Also do not Iockthe
triggeron jobs where yoursander may need to be
stopped suddenly.
DEPRESSSWITCHTRIGGERANDSWITCHACTUATORTO
STARTYOURSANDER Fig.4
STEP1:DEPRESSSWITCHTRIGGERANDSWITCH
ACTUATORwn1._YO'u'RPINGER'IIPS
Fig. 5
STEP2:RELEASESWITCHTflJGGERTO"LOCK-ON"
Fig.6
STEP3:GRASPBYHANDLEFORSANDINGwrrl.IYOUR
SANDERIN"LOCK-ON"POSITION
Fig.7
STEP4:DEPRESSSWITCHTRIGGERTO RELEASE
"LOCK-ON"FEATURE
Fig. 8