Operator`s manual

CHARGINGA HOTBATTERYPACK
Whenusingthetoolcontinuously,thebatteriesinthe
batterypackwillbecomehot.Youshouldlet a hot battery
pack cool down for approximately 30 minutes before
attempting to recharge. When the battery pack becomes
discharged and is hot, this will cause the green LED to
come on instead of the red LED. After 30 minutes, reinsert
the battery pack in the charger. If the green LED continues
to remain on, return battery pack to your nearest Sears
Repair Center for checking or replacing.
NOTE: This situation only occurs when continuous use of
the tool causes the batteries to become hot. It does not
occur under normal circumstances. Refer to "Charging
a Cool Battery Pack" for normal recharging of batteries.
If the charger does not charge your battery pack under
normal circumstances, return both the battery pack and
charger to your nearest Sears Repair Center for electrical
check.
BATTERYPACK
SHOWNIN CHARGER
CHARGER
TO iNSTALL BATTERY PACK
See Figure 3.
[] Lock switch trigger on the drill by placing the direction
of rotation selector in center position.
[] Place the battery pack in the drill. Align raised rib on
battery pack with groove in drill's battery port.
[] Make sure the latches on each side of the battery pack
snap in place and that battery pack is secured in drill
before beginning operation.
CAUTION: When placing battery pack in the tool,
be sure raised rib on battery pack aligns with the
bottom of the drill and latches into place properly.
improper installation of the battery pack can cause
damage to internal components.
TO REMOVE BATTERY PACK
See Figure 3.
[] Lock switch trigger on the drill by placing the direction
of rotation selector in center position.
[] Locate latches on side of battery pack and depress
both sides to release battery pack from the drill.
[] Remove battery pack from the drill.
RED
LED
GREEN
LED
YELLOW
LED
Fig. 2
BATTERY
PACK
LATCHES
/
DEPRESSLATCHESTO
RELEASEBATTERYPACK
Fig. 3
11