RATOR'S MANUAL 19,2 VOLT HANDHELD iNFLATOR DiGiTAL GAUGE Model No. 315.115860 A WARNING: To reduce the risk of injury, the user must read and understand the operator's manual before using this product. Customer Sears, BATTERIES AND CHARGERS SOLD SEPARATELY Help Line: 1-800-932-3188 Roebuck Visit the Craftsman and Co., 3333 Beverly Rd., Hoffman Estates, IL 60179 web page: www.sears.
• Warranty .......................................................................................................................................................................... 2 • Introduction ..................................................................................................................................................................... 2 • General Safety Rules ...................................................................................................................
A WARNING! READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all instructions listed below, may result in electric shock, fire and/ or serious personal injury. SAVE THESE WORK INSTRUCTIONS AREA [] Keep your work area clean and well lit. Cluttered benches and dark areas invite accidents. [] Keep bystanders, children, and visitors away while operating an handheld inflator. Distractions can cause you to lose control. [] Operate handheld inflator in an open area at least 18 in.
[] Never point any handheld inflator toward yourself or others. [] Keep the exterior of the handheld inflator dry, clean, and free from oil and grease. Always use a clean cloth when cleaning. Never use brake fluids, gasoline, petroleum-based products, or any strong solvents to clean the unit. Following this rule will reduce the risk of deterioration of the enclosure plastic. [] Do not exceed the pressure rating of any compo= nent in the system.
A WARNNNG! READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all instructions listed below, may result in electric shock, fire and/or serious personal injury. [] Before using battery charger, read all instructions and cautionary markings in this manual, on battery charger, battery, and product using battery to prevent misuse of the products and possible injury or damage.
Someof the followingsymbolsmaybe usedon this product.Pleasestudythemandlearntheirmeaning.Proper interpretation ofthesesymbolswillallowyoutooperatethe productbetterandsafer. SYMBOL NAME DESIGNATION/EXPLANATION V Volts Voltage A Amperes Current Hz Hertz Frequency (cycles per second) W Watt Power min Minutes Time ,%, Alternating Current Type of current Direct Current Type or a characteristic no No Load Speed Rotational speed, at no load [] Class II Tool Double-insulated ...
Thefollowingsignalwordsandmeanings areintendedto explainthelevelsofriskassociated withthisproduct. SYMBOL SIGNAL MEANING ,_ DANGER: Indicates an imminently hazardous situation, which, if not avoided, will result in death or serious injury. _, WARNING: Indicates a potentially hazardous situation, which, if not avoided, could result in death or serious injury. ,_ CAUTION: Indicates a potentially hazardous situation, which, if not avoided, may result in minor or moderate injury.
PRODUCT SPECIFICATIONS Motor .............................................................. Hose ............................................ 19.2 Volt, DC 18 in. with vehicle chuck Gauges ................. Digital readout (PSI, Kg/Cm 2, and BAR) Charger Input ................................... 120 V, 60 Hz, AC only Charge Rate ............................................................. 1 hour Air Pressure .............. 200 PSI, 13.7 BAR, 14 KG/CM2 max.
UNPACKING _, This product has been shipped completely assembled. [] Carefully remove the product and any accessories from the box. Make sure that all items listed in the packing list are included. [] Inspect the product carefully to make sure no breakage or damage occurred during shipping. [] Do not discard the packing material until you have carefully inspected and satisfactorily operated the product. [] If any parts are damaged or missing, please call 1-800-932-3188 for assistance.
LED FUNCTIONS OF CHARGER LED WILL BE ON TO INDICATE STATUS CHARGER AND BATTERY PACK: voltage range, the red LED should come on. If the red LED does not come on after 30 minutes, this may indicate a defective battery pack that should be replaced. OF [] Red LED on = Fast charging mode. [] [] Green LED on = Fully charged and in maintenance charge mode. After normal usage, a minimum of 1 hour of charging time is required to fully recharge battery pack.
Referto CHARGING A COOLBATTERY PACKfornormal recharging ofbatteries.If thechargerdoesnotcharge yourbatterypackundernormalcircumstances, return boththebatterypackandchargerto yournearestSears or otherqualifiedservicecenterforelectricalcheck. TO REMOVE BATTERY PACK See Figure 3. [] Locate the latches on the side of the battery pack and depress to release the battery pack from handheld inflator. [] Remove battery pack from handheld inflator. TO INSTALLBATTERYPACK See Figure 3.
INSTALLING/REMOVING [] Push air chuck down so that the threaded section of the valve stem is inside the air chuck. AIR HOSE See Figure 5. [] Clamp the end of the air chuck down onto the valve stem by pressing air chuck clamp down until it stops or is parallel with the air hose. [] Remove battery pack from handheld inflator. [] Loosen adaptor attachment counterclockwise. knob slightly by turning [] Insert the end of the air hose into the open end of the handheld inflator. iNFLATING WITH See Figure 7.
HiGH VOLUME ADAPTOR See Figures 11 - 12. The high volume adaptor can be useful in inflating small, low pressure items such as beach balls and children's toys. Like most adaptors provided for the handheld inflator, the high volume adaptor can be used either with or without the air hose and air chuck. Fig.9 Tousethe Prestavalve adaptor: [] Loosen Presta valve locking nut. [] Thread Presta valve adaptor onto valve stem with larger open end toward wheel.
SWITCHTRIGGER ADAPTOR See Figure 13. See Figure 14. To turn the handheld inflator ON, depress and hold the switch trigger. To turn it OFF, release the switch trigger. When not in use, adaptors provided with the handheld inflator (except those that come with the high volume adaptor) can be placed in the storage area located on the base. STORAGE TO LOCK SWITCH TRIGGER LOCK-0N BUTTON ADAPTOR STORAGEAREA TO UNLOCK Fig. 14 DiGiTAL See Figures 15- 17. Fig.
To set pressure gauge for automatic PRESSURE GAUGE shut off: [] With gauge ON, press and hold down ( + ) or ( = ) buttons to select desired shutoff pressure. NOTE: Numbers will flash while setting pressure. Holding buttons down will make the pressure number increase faster. (+) BUTTON [] When desired setting has been selected, begin inflating. Handheld inflator will shut off once setting is reached.
A A A GENERAL WARNING: When servicing, use only identical Craftsman replacement parts. Use of any other part may create a hazard or cause product damage. MAINTENANCE Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc. WARNING: Always wear safety goggles or safety glasses with side shields when using compressed air to clean products.
CRAFTSMAN HANDHELD INFLATOR - MODEL NUMBER 315.115860 The model number will be found on a plate attached to the motor housing. Always mention the model I number in all correspondence J [ SEE BACK regarding your handheld inflator PAGE FOR PARTS ORDERING 10 or when ordering repair parts. iNSTRUCTiONS 6 8 12 PARTS Key No.
