Operator`s manual

SWITCHTRIGGER
See Figure 13.
To turn the handheld inflator ON, depress and hold the
switch trigger. To turn it OFF, release the switch trigger.
SWITCH
TRIGGER
TO
LOCK
LOCK-0N
BUTTON
TO
UNLOCK
Fig. 13
NOTE: When inflating items of 10 PSI, .69 BAR, .70 KG/
CM2 or less, inflate in short bursts and check after each
burst by feel or with a calibrated measuring device to
determine accurate pressure.
LOCK-ON BUTTON
See Figure 13.
The handheld inflator is equipped with a lock-on feature,
which is convenient for continuous inflating for extended
periods of time. The lock-on button is located below the
switch trigger. To lock-on:
[] Depress the switch trigger.
[] Push the lock-on button up.
[] Release the switch trigger and the handheld inflator will
continue running.
[] To release the lock, push the lock-on button down.
If the lock-on feature is engaged during use and the
handheld inflator becomes disconnected from the power
supply, disengage the lock-on feature immediately.
NOTE: The lock-on feature only works for pressures up to
40 PSI, 2.75 BAR, and 2.80 KG/CM 2. The handheld air
compressor is designed to automatically stop at 40 PSI
2.75 BAR, or 2.80 KG/CM 2for all lock-on inflating
operations.
ADAPTOR STORAGE
See Figure 14.
When not in use, adaptors provided with the handheld
inflator (except those that come with the high volume
adaptor) can be placed in the storage area located on the
base.
ADAPTOR
STORAGEAREA
DiGiTAL GAUGE
See Figures 15- 17.
Fig. 14
The digital gauge on the handheld inflator is multifunc-
tional. It serves as a pressure gauge, monitors the amount
of pressure being applied to the item being inflated, and
can change air pressure measurement units from PSI to
BAR to KG/CM 2.
DiGiTALGAUGEAIRPRESSUREREADOUT
AIR
PRESSURE
MEASUREMENT
UNITS
Fig. 15
14