Owner`s manual

TO INSTALL OPTIONAL FLUSH CUTTING
BLADES
See Figure 11.
Flush cutting blades should be used when making
close or flush cuts to the walls.
• Unplug your saw.
_i, WARNING: Failure to unplug your saw could
result in accidental starting causing possible
serious injury.
• Using a screwdriver, loosen base pivot screw and
rotate base 180 ° as shown in figure 11.
• Slide base all the way to the rear of saw making
sure base pivot screw is in alignment with center
notch in base.
• Set the cutting angle at 0°. To set, adjust base until
0° mark on scale aligns with the parting line
located on the front of the motor housing.
• Tighten basi# pivot screw securely.
CENTERNOTCH
IN BASE
SLIDEBASE
TOTHE REAR
BASE /
PIVOTSCREW
BASE
SCREWDRIVER
Fig. 11
TO INSTALL:
• Loosen blade screw and insert flush cutting blade
as far as possible into slot in blade clamp as
shown in figure 12.
• Tighten blade screw securely.
Note: The holes in the saw blades were not
designed for alignment with the screw hole on the
blade clamp.
BLADE
SCREW ._ BLADE
CLAMP
FLUSH/ \t
cUTrlNG BLADE _ Fig. 12
OPTIONAL EDGE GUIDE
See Figure 13.
An optional edge guide, Item No. _927959, is available
for use with your saw. It can be used for making
crosscuts and rip cuts.
TO INSTALL:
• Unplug your saw.
_, WARNING: Failure to unplug your saw could
result in accidental starting causing possible
serious injury.
• Insert arm through the two slots in the base of your
saw as shown in figure 13.
• Adjust edge guide to the desired width and lock in
place with the edge guide screw.
EDGEGUIDE
SCREW
BASE
EDGEGUIDE Fig. 13
12