Instruction manual

OPERATION (Cont.)
EDGE CHAMFERING
See Figure 7.
Your planer is designed with a groove in the front
shoe. The purpose of this groove is chamfering
edges. Before making a cut on good lumber, make a
few cuts on scrap lumber to determine the amount to
be removed from the board. Holding the depth ad-
justing knob with your left hand and the rear handle
with your right hand, place the groove on the surface
to be cut and move the tool slowly into the work.
Maintain downward pressure to keep your planer flat
at the beginning and the end of the work surface.
Fig, 7
MAINTENANCE
TIMING BELT REPLACEMENT
DISCONNECT YOUR PLANER FROM POWER SUPP-
LY BEFORE CHANGING TIMING BELT.
WHEN REPLACING TIMING BELT, USE RECOM-
MENDED REPLACEMENT BELT ONLY. See Parts
List', Page 11.
1. Remove the two (2) belt cover screws. Then
remove the belt cover. See Figure 8.
2. Force old belt from small pugey with a screwdriver
and remove it from large pulley, If it is worn out,
simply cut the old belt and remove it.
3. Install new belt over large pulley first. See Figure
9.
4. Holding the belt as shownln figu_ 9, p_ssthe
belt onto the smag pulley. NOTE: TO SIMPLIFY
THE PROCESS, TURN THE LARGE PULLEY AS
YOU PRESS THE BELT ONTO THE SMALL
PULLEY.
5. Reassemble belt cover and screws.
BELT COVER IS PART OF THE
DOUBLE INSULATED SYSTEM. NEVER ATTEMPT
TO OPERATE YOUR PLANER WITHOUT BELT
COVERIN PLACE.
SMALL PULLEY
BELT COVER
LARGE PULLEY TIMING BELT
POSITION HERE AND
TURN LARGE PULLEY
COVER
SCREWS
Fig, 8
LARGE PULLEY
Fig. 9
Page 7