Instruction manual

GENERAL
O'gy the parts shown on parts list, page eleven, are
intended to be repaired or replaced by the customer
All other parts represent an important part of [he
double insulation system and Should be serviced on-
ly by a qualified service technician
Avoid using solvents when cleanlng plastic parts
Most plastics are susceptible to various types of
commercial Solvents and may be damaged by their
usa Use clean cJoths to remove dirt, carbon dusl
etc.
When electric tools are used on fiberglass bo_ts
sports cars, elc.. it has been found that they are sub
ject to accelerated wear and possible prenl_t_re
failure, as the fiberglass chips and grindings are
highly abrasive to bearings, brushes, commutator
etc Consequently it is not recommended 1hat this
too_ be used for extended work on any fibergtass
material During any use on fibe(glass it is exlremely
importanl that the tool i5 cleaned frequentJy by blow
mg with an air jet ALWAYS WEAR SAFETY
GLASSES, DUST MASK, OR EYE SHIELDS BEFORE
BEGINNING POWER TOOL OPI_RAT]ON OR BLOW-
ING DUST.
LUBRICATION
AI! the bearings in this tool are lubricated with a suf
fieient amount of high grade lubricant for the life of
the unit under normal operating condffions,
Ulerefore no further lubrication is required.
EXTENSION COROS
The use o{ any extension cord wid cause some loss
of power¸ To keep the loss to a minimum and to pro-
vent tool overhealing, follow the r_eommended cord
sizes on the chart at right When tool is used out.
doors, use only extension cords suitable for ouldoor
use and so marked Extension cords are available at
Sears Retail Stores
Extension Cord Length Wire Size A.W.G.
25 50 Ft 18
50-100 FT 16
_THE FOLLOWING RECOMMENDED ACCESSORIES ARE CURRENT AND '
WERE AVAILABLE AT THE TIME THIS MANUAL WAS PRINTED,
I'RRFTSMRN. Edge Guide ( 9 1732g) Blades 9 1;'324
The use of attachments or accessories not listed above might be hazardous.
REMEMBER:
Replace blades when they become dull.
Glean blades often.
Periodically remove chip build-up behind t he blades.
Periodically clean chip bugd-up in the chip exhaust.
NOTE: It may be necessa_ to remove blades in order to
clean them or to clean chip build up behind the blades See
BLADE REPLACEMENT for proper instructionson how Io
remove and instarr blades for cleaning
Page g