Owner`s manual

TROUBLESHOOTING
PROBLEM
1, Router will not start -- indicator lights
do not flash.
2. Router will not start -- top two indicator
lights flash.
J .,, J
3. Any unusual router condition, or abnormal
flashing of lights.
4. Your router becomes overloaded and shuts
off. The "too slow" and "too fast" Indicator
lights begin flashing:
5. The "too slow" Indicator light does not
flash or flashes inconsistently.
6. The indicator lights do not shift when you
push the "select" region.
SOLUTION
1. (a)Maka sure your router is properly plugged
Into power supply.
(b) Make sure spindle lock is in unlocked
position.
2. The switch of your router is not In the
"off" position, NOTE: Any time your router is
disconnected from power supply and the
switch is locked In the "lock on" position,
this condition will exist.
.
4.
.
DisconneCt your router from power supply,
then plug it In again.
Turn the trigger switch to Its full "off"
position, walt a few seconds, then restart
your router and continue routing at a slower
rate of feed.
This condition exists because of low voltage
conditions in the power supply. Continue
to use your router as normal.
6. Firmly press the "select" region to clean
away sawdust, etc. that has collected on the
contacts.
HELPFUL HINTS
• Always clamp workplace securely before routing,
• A safe operator is one who thinks ahead.
• Always wear eye protection when routing.
• Make set-up adjustments carefully, Then double check. Measure twlce and out once.
• Keep cutters clean and properly sharpened.
• Don't Tat familiarity make.you careless.
• Study all safety rules and do the job safely.
• NEVER place your hands in jeopardy,
• Make certain clamps can't loosen while in use.
• Test difficult set-ups on scrap -- Don't waste lumber.
• Plan each operation before you begin.
• THINK SAFETY BY THINKING AHEAD.
Page 13