User Manual

ManualsBrandsCraftsman ManualsPower saws315.212100

Owner's Manual

ACCESSORIES for model nos. 315.212100 and 315.212110

10 in. (254 mm) COMPOUND MITER SAW

instructions before first use of ■

this product. n

Customer Help Line: 1-800-932-3188

Sears, Roebuck and Co.. Hoffman Estates, IL 60179 USA

Visit the Craftsman web page;

www.sears.com/craftsman

INSTALLATION

SERVICES

972000-603

2-00

Summary of content (4 pages)

PAGE 1
Owner's Manual ACCESSORIES for model nos. 315.212100 and 10 in. (254 mm) COMPOUND MITER SAW instructions before first use of this product. Customer Help Line: 1-800-932-3188 Sears, Roebuck and Co.. Hoffman Estates, IL 60179 USA Visit the Craftsman web page; www.sears.com/craftsman 972000-603 2-00 ■ n 315.
PAGE 2
RULES FOR SAFE OPERATION READ ALL INSTRUCTIONS ■ READ THESE INSTRUCTIONS AND THE IN STRUCTIONS FOR THE 315.212100 COM POUND MITER SAW THOROUGHLY before using accessories. ALWAYS WEAR SAFETY GLASSES. Everyday eyeglasses have only impact-resistant lenses; they are NOT safety glasses. ALWAYS DISCONNECT SAW FROM POWER SUPPLY BEFORE MAKING ADJUSTMENTS OR ADDING ACCESSORIES. Make sure the switch is off when reconnecting to power supply. ■ KNOW YOUR POWER TOOL.
PAGE 3
INSTALLATION WARNING: To prevent accidental starting that could cause possible serious personal injury, assemble all parts to your saw completely before connecting it to power supply. Saw should never be connected to power supply when you are assembling parts, making adjustments, installing or removing blades or accessories, or when not in use, WORK CLAMP See Figure 2. The work clamp provides greater control by clamping the workpiece to the fence.
PAGE 4
INSTALLATION STOP BLOCK Tighten small wing screw securely. See Figures 5 and 6. Make a test cut in scrap material and measure the length of the workpiece. The stop block is useful as a slop for cutting multiple pieces to the same length. It can be installed on either table extension on either side of the saw base; ■ Slide the stop block on the back arm of either table extension, then insert the table extension into the saw base. See Figure 5.