Operator`s manual

MARKINGSON
THROATPLATE
Fig.42
CUTTINGWARPEDMATERIAL
Rgums 43 - 44.
When cuttingwarped material,elwaysmake sureit is
positioneo'on the miter tablewith the convex side
againstthe fence as shown in figure43.
Ifthe warped material ispositionedthewrong way as
shownin figure44, it willpinchthe blade nearthe comple-
tionof the cut.
WRONG
Fig. 44
_lk WAJRHtN,G: To avo_ a kickback_ to avoid
asdous personalinjury,never positiontheconcave
edge of bowedor warped material against the fence.
CLAMPING WIDE WORKPIECES
See Figure45.
When cuttingwide workpiecassuch as a 2 in. x 6 in.,
boardsshouldbe damped with a C-clampas shown In
figure45.
WIDE
UOARD
RIGHT
Fig. 43
Fig. 45
31