Operator`s manual

• DON'TABUSECORD.Nevercarrytoolbythecordor
yankitto disconnectfromreceptacle.Keepcordfrom
heat,oil,andsharpedges.
• PROTECTYOURLUNGS.Wearafaceordustmaskif
thecuttingoperationisdusty.
• PROTECTYOURHEARING.Wearhearingprotection
duringextendedperiodsofoperation.
• KEEPTOOL DRY, CLEAN, AND FREE FROM OIL
AND GREASE. Always use a clean cloth when clean-
ing. Never use brake fluids, gasoline, petroleum-based
products, or any solvents to clean tool.
• INSPECT TOOL CORDS AND EXTENSION CORDS
PERIODICALLY and, if damaged, have repaired by a
qualified service technician. Stay constantly aware of
cord location and keep it well away from the rotating
wheel.
• NEVER USE IN AN EXPLOSIVE ATMOSPHERE.
Normal sparking of the motor could ignite fumes.
• USE ONLY OUTDOOR EXTENSION CORDS with
approved ground connection that are intended for use
outdoors and so marked.
• KEEP HANDS AWAY FROM CUTTING AREA. Do not
reach underneath the table or in the cutting path with
your hands or fingers at any time while the tool is
connected to a power source.
• DO NOT use awkward hand positions.
• USE OVERHEAD GUARD WHEN ADJUSTABLE
FENCE IS NOT IN PLACE.
• FIRMLY CLAMP OR BOLT THE ROUTER TABLE TO
A WORK SURFACE so that the router table surface is
approximately hip height.
• INSPECT FOR AND REMOVE ALL NAILS FROM
LUMBER BEFORE ROUTING. Following this rule will
reduce the risk of serious personal injury.
• DRUGS, ALCOHOL, MEDICATION. DO NOT
OPERATE TOOL WHILE UNDER THE INFLUENCE
OF DRUGS, ALCOHOL, OR ANY MEDICATION.
Following this rule will reduce the risk of electric shock,
fire, or serious personal injury.
• SAVE THESE INSTRUCTIONS. Refer to them
frequently and use them to instruct others who may
use this tool. If you loan someone this tool, loan them
these instructions also.
_ WARNING" Some dust created by power sanding, sawing, grinding, drilling, and other construction activities
contains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these
chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure
to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust
masks that are specially designed to filter out microscopic particles.