Owner`s manual

MAINTENANCE
GENERAL
Only the parts shown on parts list, page 11, are intended to
he repaired or replaCed by the customer. All other pads
represent an important pad of the double insulationsystem
and should be serviced only by a qualified Sears service
technician,
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to vadous typosof commercial SOl-
vents and may be damaged by thair use. Use clean cloths
to remove dirt, carbon duet, etc.
When electric tools are used on fiberglass boats, sports
cars, wallboard, spackling compounds, or plaster, it has
been found that they ara subject to accelerated wear and
passible premature faikJre, as the fiberglass chips and
grlndings are highly abrasive to bearings, brushes,
COmmUtator,etc. Consequently it is not recommended that
this too_beusedforextended _nt on anyfiberglassmaterial,
wallboard, spacking compounds, or piaster. During any
use On fiberglass it is extremely important that the tooJ is
cleaned frequentlyby blowing with an air jet,
LUBRICATION
All ofthe bearings inthis toolare hibdcated with a sufficientamount of high grade lubricantfor the life of the unitunder norma;
operating conditions, Therefore. no further lubricationis required.
CRAFTSMAN CHUCK KEY HOLDER
1, F_rmaiaopbyforcingendwithroundholasthroughslotledbele0noppositeend. See Figure13.
2. Place the lOOpor'el the cord and pull ittight. See Figure 14.
3, Mountthechuckkeybytosertingthegearedendthroughtheholelntheholder, Largekeysintbeiargerhoia, smetlerkeys
inthe small hole. See Figure 15.
Fig. 13
CORD
Rg. 14 Rg. 15
Page 10