PERATOR'S MANUAL MANUAL DEL OPERADOR 19,2 VOLT STRING TRIMMER 19,2 V RECORTADORA DE HILO MODEL NO. 315.CR2000 NOMERO DE MODELO 315.CR2000 A A WARNING: To reduce the risk of injury, the user must read and understand the operator's manual before using this product. ADVERTENCIA: Para reducir el riesgo de lesiones, el usuario debe leer y comprender el manual del operador antes de usar este producto.
ENGLISH ESPAI_OL [] Warranty ...................................................................... 2 [] Garant[a ...................................................................... 2 [] Introduction ................................................................. 2 [] Introducci6n ................................................................ 2 [] Important Safety Instructions ................................. 3-4 [] Instrucciones [] Symbols .......................................
A [] Use Right Appliance - Do not force tool. Use the correct tool for your application. The correct tool will do the job better and safer at the rate for which it is designed. WARNING! When using electric gardening appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock and personal injury. [] Don't Force Appliance - It will do the job better and with less likelihood of a risk of injury at the rate for which it was designed.
[] Maintaina firmgripon bothhandleswhiletrimming. Keepstringheadbelowwaistlevel.Nevercutwith thestringheadlocatedover30 in.or moreabovethe ground. [] Storeidleappliances indoors- Whennotin use,string trimmershouldbestoredindoorsina dry,lockedplace out ofthereachofchildren. [] Neveruseblades,flailingdevices,wireor rope.Unit is designedfor linetrimmeruseonly.Useofanyother accessories or attachments will increasetheriskof injury. [] Inspectareato becut.Removeobjects(rocks,broken glass,nails,wire,string,etc.
Thefollowingsignalwordsandmeanings areintendedto explainthe levelsof riskassociatedwiththisproduct. SYMBOL SIGNAL MEANING ,_ DANGER: Indicates an imminently hazardous situation, which, if not avoided, will result in death or serious injury. ,_ WARNING: Indicates a potentially hazardous situation, which, if not avoided, could result in death or serious injury. ,_ CAUTION: Indicates a potentially hazardous situation, which, if not avoided, may result in minor or moderate injury.
PRODUCTSPECIFICATIONS Motor................................................................... 19.2V DC Weight(withoutbatterypack)................................... 5.3Ibs. CuttingSwath.............................................................. 12in. Replacement SpoolPartNumber.................... 3110382AG LineSize................................................................. 0.065in. Replacement SpoolCapPartNumber .............
ATTACHINGGRASSDEFLECTOR [] Remove supplied screws with a phillips screwdriver from the trimmer head. [] Fit the grass deflector onto the raised posts on the trimmer head. See Figure 2 - 3, page L _IL WARNING: The line cut-off blade on the grass deflector is sharp. Avoid contact with the blade. Failure to avoid contact can result in serious personal injury. NOTE: The deflector should be flush to the trimmer head.
THREE=POSITION PIVOTING HEAD CUTTING TIPS See Figure 8, page iL See Figure 10, page ii. The trimmer head can be adjusted to three different positions. [] Keep the trimmer tilted toward the area being cut; this is the best cutting area. [] Remove the battery pack. [] The string trimmer cuts when passing the unit from right to left. This will avoid throwing debris at the operator. Avoid cutting in the dangerous area shown in figure 10.
EDGING See Figures 12 - 14, page iL [] Remove the battery pack. Rotate the rear handle when using the edger guide for edging sidewalks and walkways. To use the edger guide, flip down from its stored position. A A A WARNING: When servicing, use only identical replacement parts. Use of any other parts may create a hazard or cause product damage. Always hold the string trimmer away from the body keeping clearance between the body and the string trimmer.
[] Insertthestringintotheanchorholeinthe upperpartof STORINGTHE TRIMMER thespool.Windthe stringaroundthe upperpartofthe [] Remove the battery pack from the string trimmer bespoolclockwise,as shownbythe arrowsonthespool. fore storing. Placestringin the slot on upperspoolflange,leaving about6 in. extendedbeyondthe slot. Do not overfill. [] Clean all foreign material from the trimmer. Afterwindingthe string,thereshouldbeat least1/4 in. [] Store it in a place that is inaccessible to children.
CRAFTSMAN19.2VOLT I STRING TRIMMER = MODEL NUMBER 315.CR2000 number in all correspondence your STRINGto TRIMMER or when ordering repair parts. he model number will be foundregarding on a label attached the motor housing. Always mention the model SEE BACK PAGE FOR PARTS ORDERING 1 INSTRUCTIONS 3 4 8 PARTS LIST Key Part No. Number Description 1 2 3 4 5 6 7 8 9 10 11 12 Logo Label (Handle) .................. Screw (M4 x 14 mm) .................. Front Handle ..............................
- English
See this section for all the figures referenced in the operator's manual. Vea esta secci6n de la pagina para todas las figuras mencion6 en el manual del operador.
PROPEREDGINGOPERATINGPOSITION POSICIONCORRECTAPARAEL IVlANEJO DE LA CORTARBORDES A_ x,." I. B A - Direction of rotation (sentido de la rotacion) B - Best cutting area (area de corte optima) C-Dangerous cutting area (_rea de corte peligrosa) A-Knob (perilla) Fi__.
A iADVERTENClA! AI utilizar herramientas el_ctricas para el cuidado del jard[n, con el fin de reducir el riesgo de incendio, descargas el_ctricas y lesiones corporales, siempre deben seguirse ciertas medidas b_.sicas de precauci6n. LEA TODAS [] [] Evite los entornos de trabajo peligrosos - No exponga las aparato or herramienta el_ctricas a la Iluvia ni a condiciones de humedad. La introducci6n de agua en una herramienta el_ctrica aumenta el desgo de descargas el_ctricas.
[] [] [] [] En el cabezal de corte use L_nicamente hilo de repuesto del fabricante original. No use ning0n otto aditamento de corte, pot ejemplo, cable met_tlico, cuerda o producto similar. Instalar cualquier otra marca de hilo de corte en esta recortadora de hilo puede producir lesiones corporales serias. Nunca utilice la unidad si el deflector de pasto no est,. montado en su lugar yen buenas condiciones funcionamiento. AI usar la recortadora, suj_tela firmemente pot ambos mangos.
Las siguientes palabras con este producto. SiMBOLO de se_alizaci6n y sus significados SENAL tienen el objeto de explicar los niveles de riesgo relacionados SIGNIFICADO PELIGRO: Indica situaci6nserias. peligrosa muerte una o lesiones inminente, ADVERTENClA" Indica una osituaci6n peligrosa la muerte lesiones serias. posible, la cual, si no se evita, podrfa causar DD=r'^l Indica situaci6no leves.
ESPECIFICACIONES Motor.................................................................. 19,2V c.c. Anchode corte....................................... 305mm(12pulg.) Diametrodelhilo.............................. ] ,65mm(0,065pulg.) FAMILIARiCESECONSU RECORTADORADE HILO DEFLECTOR Vea la figura 1, pagina L El uso seguro que este producto requiere la comprensi6n de la informaci6n impresa en la producto yen el manual del operador as[ como ciertos conocimientos sobre el proyecto a realizar.
_k ADVERTENClA:Paraevitarunarranqueaccidental quepodr[acausarlesionescorporales serias, siempredesmontedelaherramienta el paquetede bater[asal montarlepiezasa aqu_lla. ACOPLAMIENTODEL DEFLECTOR DE HIERBA ADVERTENClA: phillips [] Ajuste el deflector de c_sped en los postes elevados del cabezal de la recortadora. NOTA: El deflector debe estar nivelado con el cabezal de la recortadora. [] Instale el tornillo incluido y apri_telo gir_ndolo en sentido horario con un destornillador phillips.
MANGO DELANTERO AJUSTABLE RECOMENDAClONES DE CORTE Vea la figura 7, p#gina ii. Vea la figura 10, pagina ii. El angulo del mango delantero puede ajustarse a 180 °. [] Mantenga la recortadora inclinada hacia el area de corte; _sa es el area Optima. [] Retire el paquete de bater[as. [] Coloque la recortadora en una supefficie plana y gire la perilla hacia la izquierda para afiojar el mango. [] Para recortar, ajuste el mango hacia arriba. [] Para cortar bordes, ajuste el mango hacia abajo.
MANGO TRASERO Vea la figura GIRATORIO 13, pagina El mango trasero cantos. giratorio RECORTE ii. se utiliza junto con la gu[a para [] [] Retire el paquete [] Empuje el bot6n del recorte la izquierda. [] Suelte el bot6n del brazo telesc6pico y gire el mango a la izquierda hasta que el bot6n del recorte de bordes quede asegurado en su lugar. A de baterfas. de bordes y gire el mango a ADVERTENClA: AI dar servicio a la unidad, s61o utilice piezas de repuesto id6nticas.
REEMPLAZO DEL HILO [] Retire el paquete de baterias. [] Vuelva a colocar el ret_n de pl_stico, el carrete y el ret_n de _ste. Consulte la secci6n Reemplazo del carrete previamente expuesta en este manual. [] Quite el carrete del cabezal del hilo. ALMACENAMIENTO Vea las figuras 15 y 16, pagina ii. NOTA: Retire todo el hilo sobrante en el carrete. [] [] [] Retire el paquete de baterias de la recortadora de hilo antes de almacenarla. Corte una pieza de hilo de aproximadamente 2,7 m (9 pies) de largo.
11- Espa_ol
® Registered ® March MC Marque Trademark Registrada / TM Trademark / SM Service / TM March de Fabrica de commerce / MD Marque / SM March deposce Mark of Sears de Servicio de Sears Brands, Brands, de Sears LLC LLC Brands, LLC © Sears Brands, LLC