Manual

STARTING/STOPPING THE SAW

See Figure 10,

Tostart the sam Depressthe switch trigger.

Ah_aysletthe b_adereach f,j_)speed,then gu)dethe saw

into theworkp]ece.

_1_ WARNING: The b)adecomingin contact w_ththe

workp]ese before It reachesfull speed could cause

the saw to "kickback" towardsyou resultingin

serious personal injury.

To stop the saw: Release the switch trigger.

NOTE: Allow the blade to come to a complete stop before

removing saw from workpleoe.

WARNING; Nways unplugthe toot whenchang-

[ngoperationsettings or when the tool is not inuse.

Failure1ounplugthe tool may result in accidentaK

starting and sedouspersona_Injury.

ADJUSTING BLADE DEPTH

See Figure11.,

Alwayskeepcorrectblade depthsalting. Thecorrect

blade depth setting for al! cuts shoutd notexceed 1/4 in,

below the matefia!being cut.More btade depth wilt

increasethe chance of kickback end cause the cut to be

rough. For more depthof cut accuracy,a scale islocated

ontheupper blade guard.

II Unplug the saw.

m Loosen depth adjustmentknob.

i Determinethe desireddepth of cut.

m Locatedepth of cut scaleon backof upperblade

guard.

aNHoldbase flat agair_._'tthe workpieceand reiseor lower

saw _nti{the indicator markon bracket alignswith

notch on bladeguard°

BI Tighten depth adjusb'nentknob securely.

DEPTHOFCUT

Fig. 10

Fig. 11