Manual

_)' WARNING: When servicing, use one,' }dentica}
Craftsman replacement parts. Use of any other parts
may create a hazard or cause product damage.
A
WARNING: Alwayswear safety goggles or safety
glasses with side shieldsdudng power tool operation
or whenblowing duel If operationis dusty,also wear
a dust mask.
GENERAL MAINTENANCE
Avoid uslngsolventswhet] cleaningplast)cparts.Most
plastics aresusceptible to damage from varioustypes of
commercia}solventsand may be damagedby their use.
Useclean cloths to removedirt, dust, o11,grease,etc.
_ll, WARNING: Do not atany time letbrakefluids,
gasoline,petroleum-basedproducts,penetrating
oils,etc., comeincontact withplasticparts°
Chemicalscandamage,weakenor destroyplastic
which may resultIn seriouspersonal injury.
Electric toots used on tibergtass material, wallboard,
spacPJ{ng compounds, or plaster are subject to
accelerated wear and possible premature failure because
the fiberglass chips and gdnd[ngs are highly abrasive to
bearings, brushes, oommutators, etc..Consequent_, we
do not recommended us)rig this too} for extended work on
these types of materials. However, ff you do work with any
of these materials, it is extremely important to clean the
tool using compressed air.
LUBRICATION
A)] of the bearings in thistoo_arelub_cated witha
sufficient amount of highgrade Jubricantfor the life of
theunit undernormal operating conditions.Therefore,no
further lubricationis required.
Onlythepadsshown on the parts list are_ntendedto
be repairedor rep}acedby the customer.AItother parts
should be replacedat a SearsServiceCenter.
22