Manual

DOUBLE INSULATION
Doublelnsulatlon tsa concept tn safetytn electric power
tools, whicheliminatesthe need for theusualthree-wire
grounded power cord_All exposedmetal parts are
isolatedfrom the internal metalmotor componentswith
protecting insulation. Double insulatedtools do not need
to be grounded.
'_ WARNING: The doubleinsulatedsystem is
intended to protect the user fromshock resulting
from a break in the tool's internalinsulation,Observe
a{tnormal safety precautionstoavoid electdcat
shock,
NOTE:Servicingof a tool withdoubteinsulationrequires
extreme care and knowledgeof the system and should
be performedonly by a qualified servicetechnician. For
eervtce,we suggest you returnthe tool to your nearest
authorizedservice center for repair.Alwaysuse origina)
factory replacementpadswhenservicing.
ELECTRICAL CONNECTION
Thistool has a precision-built electric motorr It should be
connectedto a power supplythat is 120 rolL% 60 Hz,
AC only{normalhouseholdcurrenl_.Do not operate
thistool on direct current (DC}.A substantialvoltage drop
wiltcausea toss of power and the motor will overheat,if
your toot does not operate when pluggedinto an outlet,
double-check the power supptyo
EXTENSION CORDS
When using a power tool at a considerable distance from
a power source, be sure to use an extension cord that has
the capacity to handle the current the tool will draw. An
undersized cord will cause a drop in tine voltage, resulting
in overheating and loss of power. Use the chart to deter-
mine the minimum wire size required in an extens(on cord°
Only round jacketed cords listed by Underwriter's Labora-
tories (UL) should be used,
When working outdoors with a tool, use an extension
cord that is designed for outside use. This type of cord is
designated with "WA" on the cord's jacket.
Before using any extension cord, inspect it for toose or
exposed wires and cut or worn insulation.
0-2,0 2,1-3.4 3.5-5.0 5.1-7.0 7,1-12.0 12.t-16.0
Cord Length Wire Size (A,W.G.)
25' 16 16 16 t6 14 14
50' 16 t6 16 !4 14 12
IDOL 16 I6 14 12 10 --
•"Usedon fZga_. 20 ampcir_ui!
NOTE:AWG= AmericanWireGaUge
WARNING: Keep the extension cord dear of the
working area, Posfttonthe cord so that It will not get
caught on lumber, tools or other obstruotiot_s while
you are working with a power toolo Failure to do so
can resuff inserious personal injury.
A
WARNING: Check extensioncords before each
use,ff damaged replace immediately.Neveruse tool
with a damagedcord since touching the damaged
areacoutd causeetectricalshock resuttingin serious
injury.