Manual

INSTALLING BITS
See Figure 6.
• Lock the switch trigger by placing the direction of
rotation selector in center position. See Figure 2.
• Open or close chuck jaws to a point where the
opening is slightly larger than the bit size you
intend to use. Also, raise the front of your drill
slightly to keep the bit from falling out of the chuck
jaws,
• Insert drill bit into chuck the full length of the jaws
as shown in Figure 6.
DRILLBIT CHUCKBODY
,_WARNING: Do not insert drill bit intochuck jaws
and tighten as shown in Figure 7. This could cause
drill bit to be thrown from drill resulting in possible
serious personal injury or damage to the chuck,
CHUCKJAWS
CHUCKCOLLAR
RIGHT Fig. 6
• Tighten the chuck jaws on drill bit.
• To tighten the chuck jaws on drill bit: grasp and
hold the collar of the chuck with one hand, while
rotating the chuck body with your other hand.
Note: Rotate the chuck body in the direction of
the arrow marked LOCK to tighten chuck jaws.
• Do not use a wrench to tighten or loosen the
chuck jaws.
WRONG Fig. 7
REMOVING BITS
See Figure 6,
• Lock the switch trigger by placing the direction of
rotation selector in center position. See Figure 2.
• Loosen the chuck jaws from drill bit.
• To loosen: grasp and hold the collar of the chuck
with one hand. while rotating chuck body with yur
other hand.
Note: Rotate chuck body in the direction of the
arrow marked UNLOCK to loosen chuck jaws.
• Do not use a wrench to tighten or loosen the
chuck jaws.
• Remove drill bit from chuck jaws.
9