Manual

TO iNSTALLBLADES
See Figure 3.
[] Remove battery pack.
[] Lift blade clamp lock/release lever located on front of
saw.
[] Insert saw blade between blade clamp and saw bar as
far as possible.
[] Release and lock blade clamp lever,
[] Replace battery pack.
BLADE SELECTION
To obtain the best performance from the saw, it is
important to select a specific blade for the particular
application and type of material you wish to cut. By doing
this you will get a smoother, faster cut and prolong blade
life. Replacement blades for this saw are available from
your nearest Sears retail. It is recommended you use a
T-shank blade. If a T-shank blade is not available, a high
quality U-shank may be used.
LiFT
BLADECLAMP
SAWgLADE
BLADESTORAGECOMPARTMENT
Fig. 4
HEX KEY STORAGE
See Figure 5.
[] Secure hex key on the saw base behind the rubber
covered tab. Push into place.
[] Make sure the hex key is secured before performing
any sawing operation.
[] Remove by pulling on the hex key.
HE×KEY
HEXKEY
STORAGEAREA
gLADE CLAMP
LOCK/ RELEASELEVER BLADECLAMP
Fig. 5
LASER GUIDE
See Figure 6.
Depress the laser guide switch to generate a red laser
beam on the work surface in front of the saw. Use the
laser to guide the saw along the line of cut.
LASERGUIDE
SWITCH
SAWgLADE
Fig. 3
BLADE STORAGE
See Figure 4.
A convenient feature on the saw is the blade storage
compartment. The blade storage compartment is located
on the back of the saw. It is convenient for storing extra
blades and storing blades when not in use.
[] To open: Push the door down with your thumb or
finger. Place blades in blade storage compartment.
[] To close: Push the door up with your thumb or finger.
11
Fig. 6