Manual

SWITCH REPLACEMENT

See Figures 13 & 14

1, UNPLUG YOUR ROUTER.

MAINTENANCE

2, Remove screws (A) and handle cover (B). See Figure

13.

3, NOTE THE LOCATION OF THE MOLDED BEND RE-

LIEF (C) ON THE POWER HANDLE CORD, ALSO

NOTE ALL WIRING INTHE HANDLE AND HOW EACH

LEAD IS CONNECTED TO THE SWITCH° Connec*

lionsand wiring position must be identical when instafl_

trig new switch, See Figure 13

4 Remove leads from switch (D) by inserting a 1/32"

diameter nail or pin into switch teed receptacle and

putting on lead as shown in figure _4 Remove nail or

pin with a twisting, pulling motion

5o Make lead connectionsto new switch. Push each lead

as far as possible into proper switch receptacle. Pull on

leads to check lead connections withlead receptacles.

6. Locate switch in handle and place leads so they won',t

be pinched or contact screws when handle cover i_;

replaced

7 Make sure molded bend relief (C) is correctly positioned

in switch handle, then replace handle cover and screws

8, Tighten all screws securely,

DEPTH ADJUSTING RING

ADJUSTMENTS OR REPLACEMENT

Tension on the depth adjusting ring has been factory set for

properly tightening depth of cut settings, However, extended

use may require that adjustments or replacement be made

to depth adjusting ring See Figures 15-1Z

1o UNPLUG YOUR ROUTER,

To make adjustments to depth adjusting ring=

2 _ghten or loosen lop screw in depth adjusting ring,

See Figure 15. Make adjustments with top screw onfy,

DEPTH

ADJUSTING I

BASE _

Page 10

Fig. 13

,, 11

LEAD

MOTOR

,HOUSING

DEPRESS LIP

Fig, 15