Manual

RULES FOR SAFE OPERATION (Continued)
12. PROTECT YOUR LUNGS, Wear a face or dust mask if operation Is dusty.
13, PROTECT YOUR HEARING, Wear hearing protection during extended periods of operation.
1_4oDON'T ABUSE CORD, Never carry tool by cord or yank it to disconnect from receptacle. Keep
cord from heat, oil and sharp edge&
15. SECURE WORK. Use clamps or a vise to hold work. Both hands are needed to operate the tool.
16. DON'T OVERREACH. Keep proper footing and balance at all times° Do not use on a ladder or
unstable support.
17. MAINTAIN TOOLS WITH CARE. Keep tools sharp at all times, and clean for best and safest
performance. Follow instructions for lubricating and changing accessories.
18, DISCONNECT TOOLS. When not in use, before servicing, or when changing attachments,
blades, bits, cutters, etc,, all tools should be disconnected from power supply.
19. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see that keys and
adjusting wrenches are removed from tool before turning it ono
20. AVOID ACCIDENTAL STARTING. Don't carry plugged-in tools with finger on switch. Be sure
switch is off when plugging in,
21, OUTDOOR USE EXTENSION CORDS. When tool is used outdoors, use only extension cords
suitable for use outdoor& Outdoor approved cords are mar_ed with the suffix W-A, for example -
SJTW-A or SJOW-A.
22. KEEP CUTTERS CLEAN AND SHARP. Sharp cutters minimize stalling and kickback,
23, KEEP HANDS AWAY FROM CUTTING AREA. Keep hands away from cutters. Do not reach
underneath work while cutter is rotating, Do not attempt to remove material while cutter is rotating.
24. NEVER USE IN AN EXPLOSIVE ATMOSPHERE. Normal sparking of the motor could ignite
fumes.
25. INSPECT TOOL CORDS PERIODICALLY and if damaged, have repaired at your nearest Sears
Repair Center. Stay constantly aware of cord location.
2& INSPECT EXTENSION CORDS PERIODICALLY and replace if damage&
27. KEEP HANDLES DRY, CLEAN, AND FREE FROM OIL AND GREASE. Always use a clean
cloth when cleaning. Never use brake fluids, gasoline, petroleum-based products or any strong
solvents to clean your tool,
28. STAY ALERT. Watch what you are doing and use common sense° Do not operate tool when you
are tired, Do not rush.
29. CHECK DAMAGED PARTS. Before flJrther use of the tool, a guard or other part that is damaged
should be carefulty checked to determine that it will operate properly and perform its intended
function° Check for alignment of moving parts, binding of moving parts, breakage of parts,
mounting, and any other conditions that may affect its operation, A guard or other part that is
damaged should be properly repaired or replaced by an authorized service center unless indi-
cated elsewhere in this instruction manual
30. DO NOT USE TOOL IF SWITCH DOES NOT TURN IT ON AND OFF° Have defective switches
replaced by an authorized service center.
31. Inspect for and remove aft nails from lumber before routing.
32° DRUGS, ALCOHOL, MEDICATION. Do not operate tool while under the influence of drugs,
alcohol, or any medication.
3& When servicing use only Identical Craftsman replacement parts.
34. SAVE THESE INSTRUCTIONS. Review them frequently and use them to instruct others who may
use this toot. If you loan someone this tool, loan them these instructions also.
Page 3