Manual

OPERATION
DEPTH OF CUT ADJUSTMENTS (Continued)
1, UNPLUG YOUR ROUTER.
2 Place your muter on a flat surface, unlock clamping
tever, and adjust until cutter is inside subbaso. See
Figure 3
3 Turn the depth adjusting ring until tip of cutter touches
flat surface, See Figure 4,
4 Position your router so that the cutter can extend below
the subbase for desired depth setting,
5 Turn the depth adjusting ring to obtain the desired depth
ot cuL The distance the cutter moves Canbe read on
the depth adjusting ring. Use reference pointon motor
housing to measure depth of cut° Each mark on the
depth adjusting ring indicates 1/64 inchchange in depth
setting.
6. Lock clamping lover, securing depth adjusting ring to
motor housing end base,
DEPTH STOP RINGS
See Figures 5 and 6
Your router is equipped with depth stop rings that will allow
you to set positive stops for operating your router at two
desired depths of cut
1 Release depth stop rings. To release: grasp depth stop
ring tabs with your thumb and index finger, then twisl
them apart as shown by the arrows in figure 5.
2. Using depth adiusling ring, sot cutter at lowest desired
depth of cut, Lock clamping lever. Position bottom depth
stop ring against depth adjusting ring. Hold depth stop
ring against depth adjusting ring and lock. See Figure 6.
Note: Depth stop ring ends snap together to lock
3 Unlock clamping lever and move depth adjusting ring to
set culler at second desired depth of cut Lock damping
fever Posilion top depth slop ring against depth adjusting
ring Hold deplh slop ring against depth adjusling ring
end lock See Figure 6 Note: Oeplh slop ring ends snap
together Io lock
Depth stop rings witl now provide a positive stop allowing you
to operate your rouler at two cutter depths
BASE
cu'n'ER
Page 6
-_:_ ............ _ T''"'"I"' . ' '11111I'll I I' /'., '1'11'........ L'""' Z_I"L_ ..__ .........