Manual

PRACTICEBEFOREUSE
Wesuggestthatyoupracticewithyourrouterbefore
installinga cutterandmakingcutsinwood.Check
thefollowingbeforeconnectingyourrouterto a
powersupply.
• Makesurepowersupplyis120volts,60Hz,AC
only.
• Makesurethereisnotacutterinthecollet.
• Makesurecolletdoesnotextend below the subbase.
• Plug router into power supply.
• Grasp router firmly with both hands and turn on.
HELPFUL HINTS
,/ Always clamp workpiece securely before routing.
,/ A safe operator is one who thinks ahead.
,/ Always wear eye protection when routing.
,/ Make setup adjustments carefully. Then double
check. Measure twice and cut once.
,/ Keep cutters clean and properly sharpened.
,/ Don't let familiarity make you careless.
,/ Study all safety rules and do the job safely.
,/ Never place your hands in jeopardy.
,/ Make certain clamps can't loosen while in use.
,/ Test difficult setups on scrap -- Don't waste
lumber.
,/ Plan each operation before you begin.
,/ Provide for smoother operation by cleaning your
router frequently. Shake router or blow with an air
jet to remove sawdust buildup.
t/ Think safety by thinking ahead.
STARTING/STOPPING ROUTER
• Grasp handles using both hands. See Figure 9a.
• To start router. Toggle the switch to the I position.
See Figure 9b.
• To stop router. Toggle the switch to the O position.
See Figure 9b.
HANDLE
POWER
HANDLE
( O ) TO STOP
Fig. 9a
(I)TO START
SWITCH
Fig. 9b
12