Manual

• Placethebiscuitjoinerontheworkpiecewiththe

adjustablefencerestingonthelongsideof workpiece.

Thebaseorverticalfenceshouldbeagainstthemi-

terededgeoftheworkpiece.

• Recheckthefenceheightsettingto makesureit will

notcutthroughtheworkpiece.

• Aligntheindicatormarkonthefencewiththecenter-

lineontheworkpiece.Makesurethebaseorvertical

fenceispressedflatagainstthemiterededgeofthe

workpiece.

• Plugthebiscuitjoinerintothepowersupplyandpre-

pareto cuttheslot.

• Depresstheswitchtriggerto turnonthebiscuitjoiner,

thenpushitforwardto extendthebladeintothewood.

• Whenthebaseassemblybottomsoutagainstthe

depthof cutadjustmentknobsetting,pullback,releas-

ingpressureonthespring.Thebladewillretractfrom

thebiscuitslot.

• Repeatthisprocedureforcuttingthematingslotand

allrequiredmiterjointslots.

• Onceallslotshavebeencut,placea biscuitineach

jointanddry-assembletheworkpieces.Makesure

eachjointlinesupandfits.

• Finally,disassembleworkpiecesandplaceabeadof

glueineachslot.Also,spreada beadofglueoverthe

entiresurfaceofthejoint.Reinsertthebiscuitsandas-

sembleworkpieces.

• Clampworkpiecestogetheruntilthegluesetsup.

Iftheworkpiecesareofthesamethickness,clamp

themsecurelyto a workbenchwiththeshortsidesup.

Setthefenceangleat45°. Place the biscuit joiner on

the workpiece with the adjustable fence resting on the

short side of the workpiece and the base or vertical

fence against the mitered edge of the workpiece. Fol-

low steps above to cut required slots.

NOTE: Before cutting slots, make sure the blade will

not cut through the workpiece and that both the verti-

cal and horizontal fences are pressed flat against the

mitered edge and face of the workpiece.

CUTTINGEDGEMITERSLOT

FROMLONGSIDEOFWORKPIECE

CUTTINGEDGEMITERSLOT

FROMSHORTSIDEOFWORKPIECE

Fig. 20

Fig. 21