Manual

UNPACKING
This productrequiresassembly.
• Carefullyliftsaw from the cartonby the carryinghandle
and the saw base, and place it ona level work surface.
NOTE: Thissaw isheavy.To avoid back injury,liftwith
yourlegs, not yourback, and gethelpwhen needed.
• Thissaw has been shippedwith the saw arm secured
In the down position.To release the saw arm, push
down onthe top ofthe saw arm, cut thetie-wrap, and
puttout onthe lock pin.
• Liftthe saw arm bythe handle.Hand pressureshould
remainon thesaw arm to preventsuddenrise upon
releaseofthe tiewrap.
• Inspectthe tool carefullyto make sureno breakage or
damage occurred duringshipping.
• Do not discardthe packingmaterialuntilyou have
carefullyinspected and satisfactorilyoperated1hetoot.
• The saw is factory set foraccurate cutting.After
assemb)tngit, checkfor accuracy,tt shippinghas
Influencedthe settings,referto specificprocedures
explainedtn "thismanual.
• If any parts are damaged or missing, please call
1-800-932-31B8 for seslstance.
WARNING: If any parts are miSSing,do not operate
thistooluntilthe mlss(ngparts are replaced. Farfure
to do so could resultin posalbteserious personal
injury.
,_1 WARN|NG: Do not attempt to modifythistool
or createaccessoriesnot recommended for use
withthis tool.Any suchalterationor modification is
misuseand couldresultIn a hazardouscondition
leading topossibleseriouspersonalinjury.
_IL WARNING: Do not connectto power supply until
assemblyis complete. Failure to complycould result
in accidentalstartingand possibleseriouspersonal
Jnluty.
MOUNTING HOLES
SeeFigure7.
,_ WARNING" Alwaysmake surethe compoundmiter
saw Is securelymountedto a workbench or an ap-
provedworkstand.Failureto heed thiswarningcan
res_tt in _,eriouspersonaliniury.
The compound mitersaw shouldbe permanentlymount-
ed to a firm supportingsurface suchas a workbench.
Fourboil holeshave been provided inthe saw base for
thispurpose. Eachofthe four mountingho]ssshouldbe
bolted securelyusing3/8 in. machine bolts, lockwashers,
and hex nuts(notincluded). Boltsshouldbe of sufficient
lengthto accommodatethesaw base, lockwashers,hex
nuts, axedthe thickness of the workbench.
Tightenart four bolts securely.
The hole patternfor mountingto a workbenchIs shownin
figure8. Carefullycheck the workbench after mountingto
make surethat no movementcan occur duringuse. It any
tipping, sliding,or walkingIs noted,securethe workbench
tothe floor beforeoperating.
"IRACEHOLES _,
ATTHESELOCATIONSFOR
HOLEPATTERN
/
BASE
TRACEHOLES
ATTHESELOCATIONSFOR
HOLEPA'FrERN
MOUNTINGSURFACE
Fig. 7
14