Manual

TABLEEXTENSIONS
See Figures11 - 12.
Tableextensionscan beInstalledin either the left or the
fight side ofthe base.
To Instalh
• Insertthe ends of the table extensionsintothe holesin
the side of the base and adjustthe extensionsto the
desiredlength.
• Secure extensionsin place by positioningthe clamp
bracket under the extensionbeneath the base. Orient
the clamp bracket as shown infigure 12.
• Usingthe clamp bracket boil, securethe clamp
bracket In place.
NOTE: The clamp bracketbolt threadsthroughthe
clamp bracket and tightensagainst bracket supporton
bottom ofbase, securing clamp bracketagainsttable
extensions.
ROLLER SUPPORT
See Figure 13.
• Turnthe rollersupport upsidedown.
• Spinthe wing nuton the leveler clockwiseuntilthe
wing nutis positionedin the middle of the thre=ds.
• Screwthe levelerinto the center brace ofthe roller
support.
• Turnthe reliersupport upright.
• Withthe table extensionssecuredInthe saw's base,
slidethe miler support onto the extensions.
• Tightenthe wing nut on the back of the rollersupport
secudngItto the table extensions.
• The levelermustsit firmly on the surfacethe s_w is
mountedto. Adjust the leveler up or down as needed.
• Oncethe leveleris inthe proper position,turn the lever
wing nut untilthewing nut istightagalnstthe center
brace.
TABLE
EXTENSION
BASE
CLAMP
BRACKET
CLAMP
BRACI(ETSCREW
SAWV1EWEDFROMBOTTOM
WINGNUT ROLLERSUPPORT
TABLEEXTENSION
Fig. 12
TABLE
EXTENSION
WINGNUT
LEVELER
Frg. 13
FABLE MITER
EXTENSION SAWBASE
Fig. 11
16