Manual

SQUARING THE BLADE TO THE MITER
TABLE
See Figures29 - 31.
• Unplugthe saw.
• Pull the saw arm all the way down and engage the 1ock
pin to hold the saw arm in transport position,
• Loosen the miter lock handle.
• Rotate the mitertable untilthe pointer is positioned
at0",
• Securelytighten the miter lock handle.
•Looeen bevel lock knob and setsaw arm at 0" bevel
(bladeset 90' to mltertable}, Tighten bevellock knob,
• Placea comb(nationsquareagainstthe mitertable and
thefiat part of saw blade.
NOTE: Make surethatthe square contactsthe fiatpar_
ofthe saw blade,not "thebladeteeth.
• Rotate the blade by hand and cheCk the blade-to-table
alignment at several points,
• The edge of the square and the blade should be paral-
lel.
• If thetop or bottom of the blade angles away from the
squareas shownin figure30. adjustmentsare needed.
• Usinga 10 mm wrench or adjustable wrench, loosen
the lock nut securingpositivestopadjustmentscrew.
/_eeloosenbevellockknob.
• Adjustpositivestop adjustmentscrew to bring blade
Into alignmentwith the square.
• Retightenbevel lock knob. Next, retightenIook nut
seCuringthepositivestop adjustmentscrew.Recheck
blade-to-table alignment.
NOTE: The above procedure can be used to check
squareness of the blade to the mitertable at both 0"
and 45" angles.
FENCE
MITER
TABLE
CORRECTViEWOFBLADE
SQUAREWITHMITERTABLE
FENCE
MITER
COMBINATION TABLE
SQUARE
VIEWOFBLADENOTSQUAREWITHMITER
TABLE,ADJUSTMENTSAREREQUIRED
Fig. 29
"BLADE
Fig.30
POSITIVESTHP
ADJUSTMENT
SCREWFOR
O°ANGLES
LOCK
NUT(S)
Fig. 31
22