Manual

33.9°
Fig.40
Bevel
Angte Typeof Cut
Setting
Leftside,insidecomer
33.85" 1.Topedgeofmoldingagainstfence
2. MitertablesetrJght31.62"
3.Saveleftendof cut
Right side, Inside corner
1. Bottom edge of moldingagainst fence
33.85" 2. Miter table set left 31.62"
3, Save left end ofcut
Left side, outside comer
1. Bottom edge of molding against fence
_,3.65" 2. Miter table set left 31.62"
3. Save right end ofcut
Right side, outside corner
33.85" 1. Top edge of molding againstfence
2. Miter table set right 31.62"
3, Save right end of out
molding.Alsomostwalls do not have angles of exactly
90",therefore,you willneedto finetune your settings.
When cuttingcrownmolding bythismethod the bevel
angte should be set at 0".The miter angloshouldbe set at
45"either rightor left, dopondingonthe desiredcutfor the
sppLLcation.
Usingthe markingsonthe throatplata,you canaccurately
cutAllStandard (U.S.)with 52"and 38"anglesin sizes
of 2-3/4 in.,3-5/8 in., 4-5/8 in.,and 5-1/4. Youcannot
usathe markingson the throat platowhon cuttingcrown
moldingwith 45"and 45"angles.
• Loosenthe crown molding stop by turningthe knob
countemlockwlse.
• Placethes_oplntheholeon e1_ertheteflorthadght
s_deof +_hesaw's _es. See figure41.
• With the bottom of the molding (wallaide)against the
miterfence andthe top ofthe molding(callingaide)
against the mitertable, alignwith the desiredmark on
the throat plate thenspinthe crownmoldingstop until
itfitssnugglyagainst the crown molding.
• Securethe crown moldingstop inplaca by turningthe
knobclockwise.
• Holdthe crownmoldinginplace withyour hand(the
side not securedwith the stop).
NOTE: NEVER haveyour hand insidethe no hands
zonewhile the saw Is on,
• Slowty towerthe blade Into and through the workptece,
• Releasethe switchtriggerand allowthebladeto stop
rotat'mgbefore raisingtheblade out ofworkpiace.Wait
untilthe elactflc brokestopa bladefromturningbefore
removJngtheworkplace frommitertable.
CROWNMOLDING
STOP
_._ KNOB
I
!
CUTTING MOLDING USING THE CROWN
MOLDING STOP
See Figures41 and 42.
To usethismethod for accurately cuttingcrown molding
for a 90"insideor outsidecorner,place the crown molding
upsidedown on the mitertable.
Keep in mind thatthe anglesfor crownmoldingsarevery
preciseand d]fficuitto set. Since it is very easy forthese
engtesto shift,el!settingsshoutdfirstbe tested on scrap
3O
Fig. 41